Part Number 440GRx
Revision 1.08 – October 15, 2007
Preliminary Data Sheet
440GRx
PowerPC 440GRx Embedded Processor
Features
®
• Two Ethernet 10/100/1000Mbps half- or full-
duplex interfaces. Operational modes supported
are with packet reject, Jumbo frames, and
interrupt coalescing.
• PowerPC 440 processor operating up to
667MHz with 32KB I-cache and D-cache with
parity checking.
• 16KB of on-chip SRAM.
• Up to four serial ports (16750 compatible UART).
• Selectable processor:bus clock ratios of N:1, N:2.
• External peripheral bus (32-bit data) for up to six
devices with external mastering.
• Dual bridged Processor Local Buses (PLBs) with
64- and 128-bit widths.
• Two IIC interfaces (one with bootstrap capability).
• NAND Flash interface.
• Double Data Rate 2/1 (DDR2/1) Synchronous
DRAM (SDRAM) interface operating up to
166MHz (333 MHz data transfer rate) with
optional ECC.
• SPI interface.
• General Purpose I/O (GPIO) interface.
• JTAG interface for board level testing.
• DMA support for external peripherals, internal
UART and memory.
• PCI V2.2 interface (3.3V only). Thirty-two bits at
up to 66MHz.
• Boot from PCI memory, NOR Flash on the
external peripheral bus, or NAND Flash on the
NAND Flash interface.
• Programmable interrupt controller supports
interrupts from a variety of sources.
• Optional security feature (PPC440GRx-S).
• Programmable General Purpose Timers (GPT).
• Available in RoHS compliant, lead-free package.
Description
Designed specifically to address high-end embedded
applications, the PowerPC 440GRx (PPC440GRx)
provides a high-performance, low-power solution that
interfaces to a wide range of peripherals and
Technology: CMOS Cu-11, 0.13μm.
Package: 35mm, 680-ball thermally enhanced plastic
ball grid array (TE-PBGA). RoHS compliant package
available.
incorporates on-chip power management features.
Typical power (estimated): Approximately 3.3W at
533MHz.
This chip contains a high-performance RISC
processor, on-chip SRAM, DDR2/1 SDRAM controller,
PCI bus interface, control for external ROM and
peripherals, DMA with scatter/gather support, Ethernet
ports, serial ports, IIC interfaces, SPI interface, NAND
Flash interface, an optional security feature
Supply voltages required: 3.3V, 2.5V, 1.8V (DDR2) or
2.5V (DDR1), 1.5V.
(PPC440GRx-A), and general purpose I/O.
AMCC Proprietary
1