PM450 Series
4 5 0 - 4 8 0 W AT T S S I N G L E & M U LT I P L E O U T P U T A C / D C M E D I C A L
Features
• EN61000-3-2 class A and D compliant.
• Power factor 0.98 typical.
Preliminary
• Remote sense on output 1 and output 2.
• Overvoltage protection.
• Overcurrent protection.
• Power fail detection (PFD) signal.
• 100% burn-in at full rated load.
• Remote inhibit - TTL high disables output.
• Short curcuit protection.
OPERATING
Specifications
INPUT
MTBF
3530,000 hrs @ 25ꢀC
70% minimum.
Input Voltage
90-264Vac
47Hz–67Hz
Efficiency
Frequency
ENVIRONMENTAL
Operating Temperature
Derating
Input Current
7.1A (rms) for 115Vac.
3.5A (rms) for 230Vac.
0ꢀC to 70ꢀC
Leakage current
Isolation
100µA max. @ 115Vac. 60Hz.
165µA max. @ 230Vac. 50Hz.
Derate to 50% at 70ꢀC
-40ꢀC to 85ꢀC
Storage Temperature
Relative Humidity
Input – Output: 4000VAC
Input – Ground: 1500VAC
Output – Ground: 500VAC
5%–95% non-condensing
STANDARDS AND APPROVALS
Inrush Current
OUTPUT
40A @ 115V, 80A @ 230V
Safety standards
C-Tick
UL2601-1, CSA C22.2, TUV EN60601-1
AS/NZS CISPR11 Group 1, Class A
Output Voltage
Output Current
Ripple & Noise
Line Regulation
See table
EMC standards
EN60601-1-2: 2001,EN61000-3-2, -3,
EN61000-4-2, -3, -4, -5, -6, -8, -11
See table
EMI standards
MECHANICAL
Dimensions
EN55011 Class B
2% peak to peak
0.2% maximum at full load.
See table
254x127x63.5mm
TBA.
Load Regulation
Weight
Transient Response
Max. deviation 4% recovering to 1% within
500µs after 25% load charge
Overvoltage Protection
Provided on V1 only. Set at 115%–140% of
nominal.
Overcurrent Protection
Temperature Coefficient
All outputs protected for short circuit conditions
All outputs 0.04% per ꢀC.
Holdup Time
PFD Signal
Typically 12ms at 110VAC.
Power fail detection signal. TTL logic low upon
loss of input power.
Remote inhibit
Requires an external TTL high level signal to
inhibit outputs for standard models.
350