PI74FCT16543T
PI74FCT162543T
PI74FCT162H543T
Fast CMOS 16-Bit
Latched Transceivers
ProductFeatures:
Product Description:
Pericom Semiconductor’s PI74FCT series of logic circuits are pro-
duced in the Company’s advanced 0.6 micron CMOS technology,
achieving industry leading speed grades.
CommonFeatures:
• PI74FCT16543T,PI74FCT162543TandPI74FCT162H543T
are high-speed,
low power devices with high current drive.
ThePI74FCT16543T,PI74FCT162543TandPI74FCT162H543Tare16-
bit latched transceivers organized with two sets of eight
D-type latches with separate input and output controls for each set.
For data flow from A to B, for example, the A-to-B Enable
(xCEAB) input must be LOW in order to enter data from xAx or to
take data from xBx, as indicated in the Truth Table. With xCEAB
LOW, a LOW signal makes the A-to-B latches transparent; a
subsequentLOW-to-HIGHtransitionofthexLEABsignalputsthe
Alatchesinthestoragemodeandtheiroutputsnolongerchangethe
Ainputs.WithxCEABandxOEABbothLOW,the3-stateBoutput
buffers are active and reflect the data present at the output of the A
latches. Control of data from B to A is similar, but uses the xCEBA,
xLEBA, and xOEBA inputs.
• VCC =5V±10%
• Hysteresis on all inputs
• Packagesavailable:
–56-pin240milwideplasticTSSOP(A)
–56-pin300milwideplasticSSOP(V)
PI74FCT16543TFeatures:
• High output drive: IOH = –32 mA; IOL = 64 mA
• Power off disable outputs permit “live insertion”
• Typical VOLP (Output Ground Bounce) < 1.0V
atVCC =5V,TA =25°C
PI74FCT162543TFeatures:
ThePI74FCT16543ToutputbuffersaredesignedwithaPower-Off
disable allowing “live insertion”of boards when used as backplane
drivers.
• Balanced output drivers: ±24 mA
• Reduced system switching noise
The PI74FCT162543T has ±24 mA balanced output drivers. It is
designed with current limiting resistors at its outputs to control the
output edge rate resulting in lower ground bounce and undershoot.
This eliminates the need for external terminating resistors for most
interface applications.
• Typical VOLP (Output Ground Bounce) < 0.6V
atVCC =5V,TA =25°C
PI74FCT162H543TFeatures:
• Bus Hold retains last active state during 3-state
• Eliminates the need for external pull-up resistors
The PI74FCT162H543T has “Bus Hold” which retains the input’s
last state whenever the input goes to high-impedance preventing
“floating” inputs and eliminating the need for pull-up/down
resistors.
Logic Block Diagram
1OEBA
2OEBA
1CEBA
2CEBA
1LEBA
2LEBA
1OEAB
2OEAB
1CEAB
2CEAB
1
LEAB
2LEAB
C
D
C
D
1B
0
2B0
1A
0
2A0
C
D
C
D
TO 7 OTHER CHANNELS
TO 7 OTHER CHANNELS
PS2038B
01/10/01
1