5秒后页面跳转
PCA9535AHF PDF预览

PCA9535AHF

更新时间: 2024-01-28 19:01:45
品牌 Logo 应用领域
恩智浦 - NXP /
页数 文件大小 规格书
38页 2397K
描述
Low-voltage 16-bit I2C-bus I/O port with interrupt

PCA9535AHF 技术参数

生命周期:Obsolete零件包装代码:QFN
包装说明:HVQCCN, LCC24/28,.14X.2,20针数:24
Reach Compliance Code:unknownECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.68
JESD-30 代码:R-PQCC-N24长度:5.5 mm
位数:16I/O 线路数量:16
端口数量:2端子数量:24
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:HVQCCN
封装等效代码:LCC24/28,.14X.2,20封装形状:RECTANGULAR
封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE电源:2.5/5 V
认证状态:Not Qualified座面最大高度:1 mm
子类别:Parallel IO Port最大供电电压:5.5 V
最小供电电压:2.3 V标称供电电压:3 V
表面贴装:YES技术:CMOS
温度等级:INDUSTRIAL端子形式:NO LEAD
端子节距:0.5 mm端子位置:QUAD
宽度:3.5 mmuPs/uCs/外围集成电路类型:PARALLEL IO PORT, GENERAL PURPOSE
Base Number Matches:1

PCA9535AHF 数据手册

 浏览型号PCA9535AHF的Datasheet PDF文件第2页浏览型号PCA9535AHF的Datasheet PDF文件第3页浏览型号PCA9535AHF的Datasheet PDF文件第4页浏览型号PCA9535AHF的Datasheet PDF文件第5页浏览型号PCA9535AHF的Datasheet PDF文件第6页浏览型号PCA9535AHF的Datasheet PDF文件第7页 
PCA9535A  
Low-voltage 16-bit I2C-bus I/O port with interrupt  
Rev. 1 — 11 September 2012  
Product data sheet  
1. General description  
The PCA9535A is a low-voltage 16-bit General Purpose Input/Output (GPIO) expander  
with interrupt and reset for I2C-bus/SMBus applications. NXP I/O expanders provide a  
simple solution when additional I/Os are needed while keeping interconnections to a  
minimum, for example, in ACPI power switches, sensors, push buttons, LEDs, fan control,  
etc.  
In addition to providing a flexible set of GPIOs, the wide VDD range of 1.65 V to 5.5 V  
allows the PCA9535A to interface with next-generation microprocessors and  
microcontrollers where supply levels are dropping down to conserve power.  
The PCA9535A contains the PCA9535 register set of four pairs of 8-bit Configuration,  
Input, Output, and Polarity Inversion registers.  
The PCA9535A is a pin-to-pin replacement to the PCA9535 and other industry-standard  
devices. A more fully featured device, the PCAL9535A, is available with Agile I/O  
features. See the respective data sheet for more details.  
The PCA9535A open-drain interrupt (INT) output is activated when any input state differs  
from its corresponding Input Port register state and is used to indicate to the system  
master that an input state has changed.  
INT can be connected to the interrupt input of a microcontroller. By sending an interrupt  
signal on this line, the remote I/O can inform the microcontroller if there is incoming data  
on its ports without having to communicate via the I2C-bus. Thus, the PCA9535A can  
remain a simple slave device.  
The device outputs have 25 mA sink capabilities for directly driving LEDs while consuming  
low device current.  
The power-on reset sets the registers to their default values and initializes the device state  
machine.  
Three hardware pins (A0, A1, A2) select the fixed I2C-bus address and allow up to eight  
devices to share the same I2C-bus/SMBus.  
2. Features and benefits  
I2C-bus to parallel port expander  
Pin and function compatible with PCA9535  
Operating power supply voltage range of 1.65 V to 5.5 V  

与PCA9535AHF相关器件

型号 品牌 描述 获取价格 数据表
PCA9535APW NXP Low-voltage 16-bit I2C-bus I/O port with interrupt

获取价格

PCA9535APW,118 NXP PCA9535A - Low-voltage 16-bit I²C-bus I/O por

获取价格

PCA9535BS NXP 16-bit I2C and SMBus, low power I/O port with interrupt

获取价格

PCA9535BS,118 NXP PCA9535; PCA9535C - 16-bit I2C-bus and SMBus, low power I/O port with interrupt QFN 24-Pin

获取价格

PCA9535BS-T NXP IC 16 I/O, PIA-GENERAL PURPOSE, PQCC24, 4 X 4 MM, 0.85 MM HEIGHT, PLASTIC, MO-220, SOT-616

获取价格

PCA9535C NXP 16-bit I2C-bus and SMBus, low power I/O port with interrupt

获取价格