PCM1802
SLES023B – DECEMBER 2001 – REVISED MARCH 2002
SINGLE-ENDED ANALOG-INPUT
24-BIT, 96-kHz STEREO A/D CONVERTER
FEATURES
APPLICATIONS
D
D
D
D
24-Bit Delta-Sigma Stereo A/D Converter
D
D
D
D
D
AV Amp Receiver
MD Player
Single-Ended Voltage Input: 3 V p-p
Antialiasing Filter Included
CD Recorder
Oversampling Decimation Filter
– Oversampling Frequency: ×64, ×128
– Passband Ripple: ±0.05 dB
– Stopband Attenuation: –65 dB
– On-Chip HPF (Low Cut Filter): 0.84 Hz
(44.1 kHz)
Multitrack Receiver
Electric Musical Instrument
DESCRIPTION
The PCM1802 is a high-performance, low-cost,
single-chip stereo analog-to-digital converter with
single-ended analog voltage input. The PCM1802 uses
a delta-sigma modulator with 64- or 128-times over-
sampling, and includes a digital decimation filter and
HPF (low cut filter) which removes the dc component of
the input signal. For various applications, the PCM1802
supportsmasterandslavemodesandfourdataformats
in serial interface. The PCM1802 is suitable for a wide
variety of cost-sensitive consumer applications where
good performance, 5-V analog supply, and 3.3-V digital
supply operation is required. The PCM1802 is
fabricated using a highly advanced CMOS process and
is available in the DB 20-pin SSOP package.
D
D
High Performance
– THD+N: 96 dB (Typical)
– SNR: 105 dB (Typical)
– Dynamic Range: 105 dB (Typical)
PCM Audio Interface
– Master/Slave Mode Selectable
– Data Formats: 24-Bit Left-Justified;
2
24-Bit I S; 20-, 24-Bit Right-Justified
D
D
D
Sampling Rate: 16 kHz to 96 kHz
System Clock: 256 f , 384 f , 512 f , 768 f
S
S
S
S
Dual Power Supplies: 5 V for Analog, 3.3 V for
Digital
D
Package: 20-Pin SSOP
Lead-Free Product
D
This device contains circuits to protect its inputs and outputs against damage due to high static voltages or electrostatic fields. These
circuits have been qualified to protect this device against electrostatic discharges (ESD) of up to 2 kV according to MIL-STD-883C,
Method 3015; however, it is advised that precautions be taken to avoid application of any voltage higher than maximum-rated
voltages to these high-impedance circuits. During storage or handling, the device leads should be shorted together or the device
should be placed in conductive foam. In a circuit, unused inputs should always be connected to an appropriated logic voltage level,
preferably either V
or ground. Specific guidelines for handling devices of this type are contained in the publication Guidelines for
CC
Handling Electrostatic-Discharge-Sensitive (ESDS) Devices and Assemblies available from Texas Instruments.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Audio Precision and System Two are trademarks of Audio Precision.
Other trademarks are the property of their respective owners.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
Copyright 2002, Texas Instruments Incorporated
1
www.ti.com