CONDUCTIVE POLYMER
ALUMINUM SOLID ELECTROLYTIC CAPACITORS
Higher Capacitance, Low ESR
series
CJ
Higher Capacitance, Low ESR, High ripple current.
Load life of 2000 hours at 105°C.
CJ
Higher
Capacitance,
Low ESR
SMD type : Lead free reflow soldering condition at 260°C peak correspondence.
(
)
Adapted to the RoHS directive 2002/95/EC .
CF
Specifications
Item
Performance Characteristics
Category Temperature Range –55 ~ +105°C
Rated Voltage Range
Rated Capacitance Range
Capacitance Tolerance
tan δ
2.5 ~ 16V
39 ~ 2700µF
± 20% at 120Hz, 20°C
Not more than value of Standard ratings at 120Hz, 20°C
(
)
1
ESR
Not more than value of Standard ratings at 100kHz, 20°C
(
)
2
Leakage Current
Not more than value of Standard ratings. After 2 minute's application of rated voltage. 20°C
(
)
Characteristics of Temperature Z+105°C / Z+20°C 1.25
100kHz
Impedance Ratio
Z-55°C / Z+20°C 1.25
(
)
3
Capacitance change Within ± 20% of initial value
After 2000 hours' application of rated voltage
at 105°C, capacitors meet the specified value
for life characteristics listed at right.
tan δ
150% or less of the initial specified value
150% or less of the initial specified value
Initial specified value or less
Endurance
(
)
1
ESR
(
)
2
Leakage current
(
)
3
Capacitance change Within ± 20% of initial value
After 1000 hours' application of rated voltage
at 60°C 90%RH, capacitors meet the specified
value for life characteristics listed at right.
tan δ
150% or less of the initial specified value
150% or less of the initial specified value
Initial specified value or less
Damp Heat
(
)
1
ESR
(
)
2
Leakage current
To comply with recommended conditions for
reflow soldering. Pre-heating shall be done
at 150 ~ 200°C and for 60 ~ 180 sec.
In the case of peak temp, less than 250°C,
reflow soldering shall be within two times.
In the case of peak temp, less than 260°C,
reflow soldering shall be once.
(
)
3
Capacitance change Within ± 10% of initial value
tan δ
130% or less of the initial specified value
130% or less of the initial specified value
Initial specified value or less
Resistance to
Soldering Heat
(
)
1
ESR
(
)
2
Leakage current
Measurement for solder temperature profile
shall be made at the capacitor top and the
terminal.
Marking
Navy blue print on the case top.
1 ESR measurements should be made at a point on the terminal nearest where the ternimals protrude through the plastic platform.
2 Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes at the temperature of 105°C.
3 Initial value : The value before test of examination of resistance to soldering.