5秒后页面跳转
PCA9745BTW PDF预览

PCA9745BTW

更新时间: 2024-11-15 02:52:43
品牌 Logo 应用领域
恩智浦 - NXP /
页数 文件大小 规格书
48页 1462K
描述
16-channel SPI serial bus 57 mA/20 V constant current LED driver

PCA9745BTW 数据手册

 浏览型号PCA9745BTW的Datasheet PDF文件第2页浏览型号PCA9745BTW的Datasheet PDF文件第3页浏览型号PCA9745BTW的Datasheet PDF文件第4页浏览型号PCA9745BTW的Datasheet PDF文件第5页浏览型号PCA9745BTW的Datasheet PDF文件第6页浏览型号PCA9745BTW的Datasheet PDF文件第7页 
PCA9745B  
16-channel SPI serial bus 57 mA/20 V constant current LED  
driver  
Rev. 1 — 16 June 2016  
Product data sheet  
1. General description  
The PCA9745B is a daisy-chain SPI-compatible 4-wire serial bus controlled 16-channel  
constant current LED driver optimized for dimming and blinking 57 mA  
Red/Green/Blue/Amber (RGBA) LEDs in amusement products. Each LED output has its  
own 8-bit resolution (256 steps) fixed frequency individual PWM controller that operates at  
31.25 kHz with a duty cycle that is adjustable from 0 % to 100 % to allow the LED to be  
set to a specific brightness value. An additional 8-bit resolution (256 steps) group PWM  
controller has both a fixed frequency of 122 Hz and an adjustable frequency between  
15 Hz to once every 16.8 seconds with a duty cycle that is adjustable from 0 % to 99.6 %  
that is used to either dim or blink all LEDs with the same value.  
Each LED output can be off, on (no PWM control), set at its individual PWM controller  
value or at both individual and group PWM controller values. The PCA9745B operates  
with a supply voltage range of 3 V to 5.5 V and the constant current sink LED outputs  
allow up to 20 V for the LED supply. The output peak current is adjustable with an 8-bit  
linear DAC from 225 A to 57 mA.  
Gradation control for all current sources is achieved via the 4-wire serial bus interface and  
allows user to ramp current automatically without MCU intervention. 8-bit DACs are  
available to adjust brightness levels for each LED current source. There are four  
selectable gradation control groups and each group has independently four registers to  
control ramp-up and ramp-down rate, step time, hold ON/OFF time and final hold ON  
output current. Two gradation operation modes are available for each group, one is single  
shot mode (output pattern once) and the other is continuous mode (output pattern repeat).  
Each channel can be set to either gradation mode or normal mode and assigned to any  
one of these four gradation control groups.  
This device has built-in open, short load and overtemperature detection circuitry. The error  
information from the corresponding register can be read via the 4-wire serial bus.  
Additionally, a thermal shutdown feature protects the device when internal junction  
temperature exceeds the limit allowed for the process.  
The PCA9745B device is designed to use 4-wire read/write serial bus with higher data  
clock frequency (up to 25 MHz).  
The active LOW output enable input pin (OE) blinks all the LED outputs and can be used  
to externally PWM the outputs, which is useful when multiple devices need to be dimmed  
or blinked together without using software control.  

与PCA9745BTW相关器件

型号 品牌 获取价格 描述 数据表
PCA9745BTWJ NXP

获取价格

PCA9745B - 16-channel SPI serial bus 57 mA/20 V constant current LED driver TSSOP2 28-Pin
PCA9745BTWQ900 NXP

获取价格

16-channel SPI serial bus 57 mA/20 V constant current LED driver
PCA9846BS NXP

获取价格

4-channel ultra-low voltage, Fm I2C-bus switch with reset
PCA9846PW NXP

获取价格

4-channel ultra-low voltage, Fm I2C-bus switch with reset
PCA9846PWJ NXP

获取价格

4-channel ultra-low voltage, Fm I2C-bus switch with reset
PCA9847PW NXP

获取价格

8-channel ultra-low voltage, Fm+ I2C-bus multiplexer with reset
PCA9848BS NXP

获取价格

8-channel ultra-low voltage, Fm I2C-bus switch with reset
PCA9848PW NXP

获取价格

8-channel ultra-low voltage, Fm I2C-bus switch with reset
PCA9848PWJ NXP

获取价格

8-channel ultra-low voltage, Fm I2C-bus switch with reset
PCA9849BS NXP

获取价格

4-channel ultra-low voltage, Fm I2C-bus multiplexer with reset