5秒后页面跳转
捷配首页

Datasheet > PCA9703PW,118
PCA9703PW,118 PDF预览

PCA9703PW,118

更新时间： 2024-11-14 20:58:31
品牌 Logo 应用领域
恩智浦 - NXP PC光电二极管
页数 文件大小 规格书
27页 264K
描述
PCA9703 - 18 V tolerant SPI 16-bit GPI with maskable INT TSSOP2 24-Pin

阅读下载

中文翻译

获取价格

PCA9703PW,118 技术参数

是否Rohs认证： 符合生命周期：Active
零件包装代码：TSSOP2包装说明：TSSOP, TSSOP24,.25
针数：24Reach Compliance Code：compliant
HTS代码：8542.39.00.01风险等级：1.4
JESD-30 代码：R-PDSO-G24JESD-609代码：e3
最大频率@ Nom-Sup：5000000 Hz湿度敏感等级：1
位数：16功能数量：1
端子数量：24最高工作温度：125 °C
最低工作温度：-40 °C封装主体材料：PLASTIC/EPOXY
封装代码：TSSOP封装等效代码：TSSOP24,.25
封装形状：RECTANGULAR封装形式：SMALL OUTLINE, THIN PROFILE, SHRINK PITCH
峰值回流温度（摄氏度）：NOT SPECIFIED电源：5 V
认证状态：Not Qualified子类别：Shift Registers
标称供电电压 (Vsup)：5 V表面贴装：YES
温度等级：AUTOMOTIVE端子面层：Matte Tin (Sn)
端子形式：GULL WING端子节距：0.635 mm
端子位置：DUAL处于峰值回流温度下的最长时间：NOT SPECIFIED
Base Number Matches：1

PCA9703PW,118 数据手册

 浏览型号PCA9703PW,118的Datasheet PDF文件第2页浏览型号PCA9703PW,118的Datasheet PDF文件第3页浏览型号PCA9703PW,118的Datasheet PDF文件第4页浏览型号PCA9703PW,118的Datasheet PDF文件第5页浏览型号PCA9703PW,118的Datasheet PDF文件第6页浏览型号PCA9703PW,118的Datasheet PDF文件第7页 
PCA9703  
18 V tolerant SPI 16-bit GPI with maskable INT  
Rev. 2 — 14 June 2012  
Product data sheet  
1. General description  
The PCA9703 is a low power 18 V tolerant SPI General Purpose Input (GPI) shift register  
designed to monitor the status of switch inputs. It generates an interrupt when one or  
more of the switch inputs change state but allows selected inputs to not generate  
interrupts using the interrupt masking feature. The input level is recognized as a HIGH  
when it is greater than 0.8 × VDD and as a LOW when it is less than 0.55 × VDD (minimum  
LOW threshold of 2.5 V at 5 V node). The PCA9703 can monitor up to 16 switch inputs.  
The falling edge of the CS pin samples the input port status and clears the interrupt. When  
CS is LOW, the rising edge of the SCLK loads the shift register and shifts the value out of  
the shift register. The serial input is sampled on the falling edge of SCLK. The contents of  
the shift register are loaded into the interrupt mask register of the device on the rising  
edge of CS.  
Each of the input ports has a 18 V breakdown ESD protection circuit, which dumps the  
ESD/overvoltage current to ground. When used with a series resistor (minimum 100 kΩ),  
the input can connect to a 12 V battery and support double battery, reverse battery, 27 V  
jump start and 40 V load dump conditions in automotive applications. Higher voltages can  
be tolerated on the inputs depending on the series resistor used to limit the input current.  
The INT_EN pin is used to both enable the GPI pins and to enable the INT output pin to  
minimize battery drain in cyclically supplied pull-up or pull-down applications. The SDIN  
pull-down prevents floating nodes when the device is used in daisy-chain applications.  
With both the high breakdown voltage and high ESD, this device is useful for both  
automotive (AEC-Q100 compliance available) and mobile applications.  
2. Features and benefits  
16 general purpose input ports  
18 V tolerant input ports with 100 kΩ external series resistor  
Input LOW threshold 0.55 × VDD with minimum of 2.5 V at VDD = 4.5 V  
Input hysteresis 0.04 × VDD with minimum of 180 mV at VDD = 4.5 V  
Open-drain interrupt output  
Interrupt enable pin (INT_EN) disables GPI pins and interrupt output  
Interrupt-masking feature allows no interrupt generation from selected inputs  
VDD range: 4.5 V to 5.5 V  
IDD is very low 2.5 μA maximum  
SPI serial interface with speeds up to 5 MHz  
SPI supports daisy-chain connection for large switch numbers  
AEC-Q100 compliance available  
 
 
1234567...27

中文翻译

下载PDF

PCA9703PW,118 替代型号

型号 品牌 替代类型 描述 数据表
PCA9703PW/Q900,118 NXP

完全替代

 PCA9703 - 18 V tolerant SPI 16-bit GPI with maskable INT TSSOP2 24-Pin

与PCA9703PW,118相关器件

型号 品牌 获取价格 描述 数据表
PCA9703PW/Q900 NXP

获取价格

 		IC PARALLEL IN SERIAL OUT SHIFT REGISTER, Shift Register
PCA9703PW/Q900,118 NXP

获取价格

 		PCA9703 - 18 V tolerant SPI 16-bit GPI with maskable INT TSSOP2 24-Pin
PCA9704PW NXP

获取价格

 		18 V tolerant SPI 8-bit GPI with maskable INT - AEC_Q100 compliant
PCA9704PWJ NXP

获取价格

 		PCA9704 - 18 V tolerant SPI 8-bit GPI with maskable INT TSSOP 16-Pin
PCA9745B NXP

获取价格

 		16-channel SPI serial bus 57 mA/20 V constant current LED driver
PCA9745BTW NXP

获取价格

 		16-channel SPI serial bus 57 mA/20 V constant current LED driver
PCA9745BTWJ NXP

获取价格

 		PCA9745B - 16-channel SPI serial bus 57 mA/20 V constant current LED driver TSSOP2 28-Pin
PCA9745BTWQ900 NXP

获取价格

 		16-channel SPI serial bus 57 mA/20 V constant current LED driver
PCA9846BS NXP

获取价格

 		4-channel ultra-low voltage, Fm I2C-bus switch with reset
PCA9846PW NXP

获取价格

 		4-channel ultra-low voltage, Fm I2C-bus switch with reset

与PCA9703PW,118相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证