5秒后页面跳转
捷配首页

Datasheet > 微控制器和处理器 > 并行 IO 端口> PCA9698DGG
PCA9698DGG PDF预览

PCA9698DGG

更新时间： 2024-11-14 04:35:03
品牌 Logo 应用领域
恩智浦 - NXP 并行IO端口微控制器和处理器外围集成电路光电二极管
页数 文件大小 规格书
47页 233K
描述
40-bit Fm+ I2C-bus advanced I/O port with RESET, OE and INT

阅读下载

中文翻译

获取价格

PCA9698DGG 技术参数

是否无铅： 不含铅是否Rohs认证： 符合
生命周期：Active零件包装代码：TSSOP
包装说明：6.10 MM, PLASTIC, MO-153, SOT364-1, TSSOP-56针数：56
Reach Compliance Code：compliantECCN代码：EAR99
HTS代码：8542.39.00.01风险等级：5.29
JESD-30 代码：R-PDSO-G56JESD-609代码：e4
长度：14 mm湿度敏感等级：3
位数：40I/O 线路数量：8
端口数量：2端子数量：56
最高工作温度：85 °C最低工作温度：-40 °C
封装主体材料：PLASTIC/EPOXY封装代码：TSSOP
封装等效代码：TSSOP56,.3,20封装形状：RECTANGULAR
封装形式：SMALL OUTLINE, THIN PROFILE, SHRINK PITCH峰值回流温度（摄氏度）：260
电源：2.5/5 V认证状态：Not Qualified
座面最大高度：1.2 mm子类别：Parallel IO Port
最大供电电压：5.5 V最小供电电压：2.3 V
标称供电电压：3.3 V表面贴装：YES
技术：CMOS温度等级：INDUSTRIAL
端子面层：NICKEL PALLADIUM GOLD端子形式：GULL WING
端子节距：0.5 mm端子位置：DUAL
处于峰值回流温度下的最长时间：30宽度：6.1 mm
uPs/uCs/外围集成电路类型：PARALLEL IO PORT, GENERAL PURPOSEBase Number Matches：1

PCA9698DGG 数据手册

 浏览型号PCA9698DGG的Datasheet PDF文件第2页浏览型号PCA9698DGG的Datasheet PDF文件第3页浏览型号PCA9698DGG的Datasheet PDF文件第4页浏览型号PCA9698DGG的Datasheet PDF文件第5页浏览型号PCA9698DGG的Datasheet PDF文件第6页浏览型号PCA9698DGG的Datasheet PDF文件第7页 
PCA9698  
40-bit Fm+ I2C-bus advanced I/O port with RESET, OE and INT  
Rev. 02 — 19 July 2006  
Product data sheet  
1. General description  
The PCA9698 provides 40-bit parallel input/output (I/O) port expansion for I2C-bus  
applications organized in 5 banks of 8 I/Os. At 5 V supply voltage, the outputs are capable  
of sourcing 10 mA and sinking 25 mA with a total package load of 1 A to allow direct  
driving of 40 LEDs. Any of the 40 I/O ports can be configured as an input or output.  
The PCA9698 is the first GPIO device in a new Fast-mode Plus (Fm+) family. Fm+  
devices offer higher frequency (up to 1 MHz) and longer, more densely populated bus  
operation (up to 4000 pF).  
The device is fully configurable: output ports can be programmed to be totem-pole or  
open-drain and logic states can change at either the Acknowledge (bank change) or the  
Stop Command (global change), each input port can be masked to prevent it from  
generating interrupts when its state changes, I/O data logic state can be inverted when  
read by the system master.  
An open-drain interrupt output pin (INT) allows monitoring of the input pins and is  
asserted each time a change occurs in one or several input ports (unless masked).  
The Output Enable pin (OE) 3-states any I/O selected as output and can be used as an  
input signal to blink or dim LEDs (PWM with frequency > 80 Hz and change duty cycle).  
A ‘GPIO All Call’ command allows to program multiple Advanced GPIOs at the same time  
even if they have different I2C-bus addresses. This allows optimal code programming  
when more than one device needs to be programmed with the same instruction or if all  
outputs need to be turned on or off at the same time (for example, LED test).  
The Device ID, hard coded in the PCA9698, allows the system master to read  
manufacturer, part type and revision information.  
The SMBus Alert feature allows the SMBALERT pins of multiple devices with this feature  
to be connected together to form a wired-AND signal and to be used in conjunction with  
the SMBus Alert Response Address.  
The internal Power-On Reset (POR) or hardware reset pin (RESET) initializes the 40 I/Os  
as inputs. Three address select pins configure one of 64 slave addresses.  
The PCA9698 is available in 56-pin TSSOP and HVQFN packages and is specified over  
the −40 °C to +85 °C industrial temperature range.  
2. Features  
I 1 MHz Fast-mode Plus I2C-bus serial interface  
I Compliant with I2C-bus Fast-mode (400 kHz) and Standard-mode (100 kHz)  
1234567...47

中文翻译

下载PDF

PCA9698DGG 替代型号

型号 品牌 替代类型 描述 数据表
PCA9698DGG,512 NXP

完全替代

 PCA9698 - 40-bit Fm+ I2C-bus advanced I/O port with RESET, OE and INT TSSOP 56-Pin

与PCA9698DGG相关器件

型号 品牌 获取价格 描述 数据表
PCA9698DGG,512 NXP

获取价格

 		PCA9698 - 40-bit Fm+ I2C-bus advanced I/O port with RESET, OE and INT TSSOP 56-Pin
PCA9698DGG/G,118 NXP

获取价格

 		PCA9698 - 40-bit Fm+ I2C-bus advanced I/O port with RESET, OE and INT TSSOP 56-Pin
PCA9698DGG/S911,51 NXP

获取价格

 		IC 8 I/O, PIA-GENERAL PURPOSE, PDSO56, 6.10 MM, PLASTIC, MO-153, SOT364-1, TSSOP-56, Paral
PCA9701 NXP

获取价格

 		18 V tolerant SPI 16-bit/8-bit GPI with INT
PCA9701_09 NXP

获取价格

 		18 V tolerant SPI 16-bit/8-bit GPI with INT
PCA9701D NXP

获取价格

 		18 V tolerant SPI 16-bit/8-bit GPI with INT
PCA9701D,112 NXP

获取价格

 		PCA9701; PCA9702 - 18 V tolerant SPI 16-bit/8-bit GPI with INT SOP 24-Pin
PCA9701D,118 NXP

获取价格

 		PCA9701; PCA9702 - 18 V tolerant SPI 16-bit/8-bit GPI with INT SOP 24-Pin
PCA9701D-T NXP

获取价格

 		IC,SHIFT REGISTER,SOP,24PIN,PLASTIC
PCA9701HF NXP

获取价格

 		18 V tolerant SPI 16-bit/8-bit GPI with INT

与PCA9698DGG相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证