5秒后页面跳转
PCA9551PW,112 PDF预览

PCA9551PW,112

更新时间: 2024-02-04 03:54:40
品牌 Logo 应用领域
恩智浦 - NXP PC驱动光电二极管接口集成电路
页数 文件大小 规格书
26页 169K
描述
PCA9551 - 8-bit I2C-bus LED driver with programmable blink rates TSSOP 16-Pin

PCA9551PW,112 技术参数

是否Rohs认证: 符合生命周期:Obsolete
零件包装代码:TSSOP包装说明:TSSOP, TSSOP16,.25
针数:16Reach Compliance Code:compliant
HTS代码:8542.39.00.01风险等级:5.12
数据输入模式:SERIAL接口集成电路类型:LED DISPLAY DRIVER
JESD-30 代码:R-PDSO-G16JESD-609代码:e4
长度:5 mm湿度敏感等级:1
复用显示功能:NO功能数量:1
区段数:8端子数量:16
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:TSSOP
封装等效代码:TSSOP16,.25封装形状:RECTANGULAR
封装形式:SMALL OUTLINE, THIN PROFILE, SHRINK PITCH峰值回流温度(摄氏度):260
电源:2.5/5 V认证状态:Not Qualified
座面最大高度:1.1 mm子类别:Display Drivers
最大供电电压:5.5 V最小供电电压:2.3 V
标称供电电压:3.3 V表面贴装:YES
温度等级:INDUSTRIAL端子面层:NICKEL PALLADIUM GOLD
端子形式:GULL WING端子节距:0.65 mm
端子位置:DUAL处于峰值回流温度下的最长时间:30
宽度:4.4 mm最小 fmax:0.4 MHz
Base Number Matches:1

PCA9551PW,112 数据手册

 浏览型号PCA9551PW,112的Datasheet PDF文件第2页浏览型号PCA9551PW,112的Datasheet PDF文件第3页浏览型号PCA9551PW,112的Datasheet PDF文件第4页浏览型号PCA9551PW,112的Datasheet PDF文件第5页浏览型号PCA9551PW,112的Datasheet PDF文件第6页浏览型号PCA9551PW,112的Datasheet PDF文件第7页 
PCA9551  
8-bit I2C-bus LED driver with programmable blink rates  
Rev. 08 — 31 July 2008  
Product data sheet  
1. General description  
The PCA9551 LED blinker blinks LEDs in I2C-bus and SMBus applications where it is  
necessary to limit bus traffic or free up the I2C-bus master's (MCU, MPU, DSP, chip set,  
etc.) timer. The uniqueness of this device is the internal oscillator with two programmable  
blink rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the  
bus master must send repeated commands to turn the LED on and off. This greatly  
increases the amount of traffic on the I2C-bus and uses up one of the master's timers.  
The PCA9551 LED blinker instead requires only the initial set-up command to program  
BLINK RATE 1 and BLINK RATE 2 (i.e., the frequency and duty cycle) for each individual  
output. From then on, only one command from the bus master is required to turn each  
individual open-drain output on, off, or to cycle at BLINK RATE 1 or BLINK RATE 2.  
Maximum output sink current is 25 mA per bit and 100 mA per package.  
Any bits not used for controlling the LEDs can be used for General Purpose parallel  
Input/Output (GPIO) expansion.  
The active LOW hardware reset pin (RESET) and Power-On Reset (POR) initializes the  
registers to their default state, all zeroes, causing the bits to be set HIGH (LED off).  
Three hardware address pins on the PCA9551 allow eight devices to operate on the same  
bus.  
The newer Fast-mode Plus PCA9634 8-bit LED controller offers an individual PWM  
dimming control for each channel for better color mixing capabilities with a global PWM for  
dimming or blinking all channels at the same time. There are 126 possible address  
combinations and the maximum output sink current is 25 mA per bit and 200 mA per  
package.  
2. Features  
I 8 LED drivers (on, off, flashing at a programmable rate)  
I 2 selectable, fully programmable blink rates (frequency and duty cycle) between  
0.148 Hz and 38 Hz (6.74 seconds and 0.026 seconds)  
I Input/outputs not used as LED drivers can be used as regular GPIOs  
I Internal oscillator requires no external components  
I I2C-bus interface logic compatible with SMBus  
I Internal power-on reset  
I Noise filter on SCL/SDA inputs  
I Active LOW reset input  
I 8 open-drain outputs directly drive LEDs to 25 mA  
I Edge rate control on outputs  
 
 

与PCA9551PW,112相关器件

型号 品牌 描述 获取价格 数据表
PCA9551PW,118 NXP PCA9551 - 8-bit I2C-bus LED driver with programmable blink rates TSSOP 16-Pin

获取价格

PCA9551PW-T NXP 暂无描述

获取价格

PCA9552 NXP 16-bit I2C LED driver with programmable blink rates

获取价格

PCA9552_06 NXP 16-bit I2C-bus LED driver with programmable blink rates

获取价格

PCA9552BS NXP 16-bit I2C LED driver with programmable blink rates

获取价格

PCA9552BS,118 NXP PCA9552 - 16-bit I2C-bus LED driver with programmable blink rates QFN 24-Pin

获取价格