February 1999
PBL 386 10/2
Subscriber Line
Interface Circuit
Description
Key Features
• Selectable overhead voltage principle
– All adaptive: The overhead voltage
follows 0.6 VPeak < signals < 5 VPeak
– Semi adaptive: The overhead voltage
follows 2.5 VPeak < signals < 5 VPeak
• Metering 1.6Vrms
The PBL 386 10/2 Subscriber Line Interface Circuit (SLIC) is a 90 V bipolar integrated
circuit for use in PBX, Terminal adapters and other telecommunications equipment.
The PBL 386 10/2 has been optimized for low total line interface cost and a high
degree of flexibility in different applications.
The PBL 386 10/2 emulates a transformer equivalent dc-feed, programmable
between 2x25 Ω and 2x900 Ω, with short loop current limiting adjustable to max
65 mA.
A second lower battery voltage may be connected to the device to reduce short
loop power dissipation. The SLIC automatically switches between the two battery
supply voltages without need for external components or external control.
The SLIC incorporates loop current, ground key and ring trip detection functions. The
PBL 386 10/2 is compatible with loop start signalling.
.
.
• High and low battery with automatic
switching
• Battery supply as low as -10V
• Only +5V in addition to GND
and battery (VEE optional)
Two- to four-wire and four- to two-wire voice frequency (vf) signal conversion is
accomplished by the SLIC in conjunction with either a conventional CODEC/filter or
with a programmable CODEC/filter, e.g. SLAC, SiCoFi, Combo II. The programmable
line terminating impedance could be complex or real to fit every market.
Longitudinal line voltages are suppressed by a feedback loop in the SLIC and the
longitudinal balance specifications meet Bellcore TR909 requirements.
The PBL 386 10/2 package is 28-pin PLCC.
• 35 mW on-hook power dissipation in
active state
• Long loop battery feed tracks VBat for
maximum line voltage
• 44V open loop voltage @ -48 V battery
feed
• Constant loop voltage for line
leakage <5 mA
• On-hook transmission
• Full longitudinal current capability
during on-hook
Ring Relay
Driver
RRLY
• Programmable loop & ring-trip detector
threshold
DT
DR
C1
C2
Ring Trip
Comparator
• Ground key detector
• Analog temperature guard
• Integrated Ring Relay Driver
Input
Decoder and
Control
TIPX
C3
Ground Key
Detector
RINGX
VCC
DET
HP
TS
Line Feed
Controller
and
Longitudinal
Signal
PSG
LP
Two-wire
Interface
REF
PLC
VEE
Suppression
PBL
AOV
Off-hook
Detector
PLD
VBAT2
386 10/2
AGND
VTX
VBAT
VF Signal
Transmission
RSN
VEE
BGND
28-pin plastic PLCC
Figure 1. Block diagram.
1