P8SG-xxxxE/Z(Hxx)LF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
peak@peak-electronics.de
PM5-SERIES
ꢀ 1.5 Watt
ꢀ Regulated
Rev.11-2008
ꢀ DIP24 Plastic Case
ꢀ 1 - 6 kV DC I/O Isolation
ꢀ Single and Dual Output
ꢀ Continuous Short Circuit Prot.
ꢀ Full SMD Technology
The PM5 series P8SG-xxxxE/Z(Hxx)LF is a family of cost effective 1.5 W
single and dual output DC/DC converters. These converters are
encapsulated in an ultra miniature DIP24 case. High performance features:
1000VDC, optional up to 6000VDC input/output isolation, high efficiency
operation, output voltage accuracy of ±2% maximum, input range of ±10%
tolerance and low output ripple and noise.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
10%
Pi Type
35 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
2%
Indefinite (automatic recovery)
0.5%
Load Regulation (0% - 100%)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
0.5% (3.3Vout Models: 1.5%)
75 mV pk-pk
0.02% / °C
General Specifications
Efficiency
See Table
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency (typical)
Humidity
1000 VDC (up to 6000 VDC optional)*
60 pF, typ.
1000 M Ohm
40 kHz (Single out); 350 kHz (Dual out)
95% rel H
Reliability Calculated MTBF (MIL-HDBK-217F) > 3.072 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 12.5g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
-40 to +85°C (ambient)
100°C
-40 to +125°C
Free Air Convection
Soldering 260°C, max. (1.5mm from case 10s.)
RoHS Conform
PM5-Series – P8SG-xxxxE/Z(Hxx)LF – Single and Dual Output – DIP24 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3