P3T1755
I3C, I2C-bus interface, 0.5 °C accuracy, digital temperature
sensor
Rev. 1.1 — 4 January 2023
Product data sheet
1 General description
The P3T1755 is a temperature-to-digital converter from -40 °C to +125 °C range. It
uses an on-chip band gap temperature sensor and A-to-D conversion technique with
an overtemperature detection. The device contains a number of configuration and data
registers to store the device settings, such as device operation mode, and a temperature
register (Temp) to store the digital temp reading that can be communicated by a
controller via the 2-wire serial I3C (up to 12.5 MHz) and I2C (up to 3.4 MHz) interface.
The I2C interface supports up to 32 target addresses and an alert function which
becomes active when the temperature exceeds the programmed limits.
The I3C interface supports IBI (In Band Interrupt) where P3T1755 emits its address into
the arbitrated address header on the I3C bus to notify the controller of an interrupt. It
does not require an additional interrupt pin.
The P3T1755 can be configured for different operation conditions. It can be set in normal
mode to periodically monitor the ambient temperature, or in shut-down mode to minimize
power consumption. The temperature register always stores a 12-bit two's complement
data, giving a temperature resolution of 0.0625 °C.
The Alert output operates in either of two selectable modes: Alert comparator mode or
Alert interrupt mode. Its active state can be selected as either HIGH or LOW. The fault
queue that defines the number of consecutive faults in order to activate the Alert output is
programmable as well as the set-point limits.
2 Features and benefits
• I3C (up to 12.5 MHz) and I2C (up to 3.4 MHz) interface
– 32 I2C target addresses
– 32 I3C Provisional-ID
• Supply range: 1.4 V to 3.6 V
• Programmable overtemperature alerts
• Resolution: 12 bits (0.0625 °C)
• Accuracy:
– 1.4 V < VCC < 3.6 V
– ±0.5 °C (maximum) from –20 °C to +85 °C
– ±1 °C (maximum) from -40 °C to +125 °C
• Low quiescent current: 4.1 μA supply current (typical)
• ESD protection exceeds 2000 V HBM per JS-001-2017 and 1000 V CDM per
JS-002-2018
• Package: TSSOP8
• P3T1755DP/Q900 for automotive