P22TG-xxxxE/Z2:1(H35)LF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
peak@peak-electronics.de
PMD-SERIES
ꢀ 5 Watt
ꢀ 2:1 Wide Input
Rev.11-2008
ꢀ Reg. Single and Dual Output
ꢀ 1.5 to 3.5 kV DC I/O Isolation
ꢀ DIP24 Case
ꢀ Continuous Short Circuit Prot.
ꢀ Full SMD Technology
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
The PMD 5W series P22TG-xxxxE/Z2:1(H35)LF is a family of cost effective
5W single & dual output DC-DC converters. These converters are
encapsulated in miniature DIP24 plastic case. High performance features:
1500VDC up to 3500VDC input/output isolation, continuous short circuit
protection with automatic restart and tight line / load regulation, high
efficiency operation, output voltage accuracy of ±1% maximum and a wide
input range of 2:1
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
2:1 Wide Input
Pi Type
35 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
Load Regulation
1%
Indefinite (automatic recovery)
0.5%
0.5% (3.3 / 3.3Vout Models: 1.5%)
60 mV pk-pk
0.02% / °C
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
General Specifications
Efficiency
See Table
1500 VDC (3500 VDC optional)*
470 pF, typ.
1000 MOhm
266 kHz
95% rel H
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency (typical)
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F) > 1.121 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 13.5g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
-40 to +85°C (ambient)
100°C
-40 to +125°C
Free Air Convection
Soldering 260°C, max. (1.5mm from case 10s.)
RoHS Conform
PMD-Series – P22TG-xxxxE/Z2:1(H35)LF – Single and Dual Output – DIP24 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/3