P10CU-xxxxE/Z LF
Mainzer Straße 151–153
D-55299 Nackenheim
Tel. +49 6135 7026-0
Fax: +49 6135 931070
www.peak-electronics.de
peak@peak-electronics.de
PM3-SERIES
ꢀ 2 Watt
ꢀ Unregulated
Rev.02-2009
ꢀ Single and Dual Output
ꢀ SIP7 Case
ꢀ 1 kV DC I/O Isolation
ꢀ Low Ripple and Noise
The PM3 series P10CU-xxxxE/ZLF is a family of cost effective 2 W single &
dual output DC-DC converters. These converters are in an ultra miniature
SIP7 case. Devices are encapsulated. High performance features:
1000VDC input/output isolation, high efficiency operation, output voltage
accuracy of ±3% maximum, input range of ±10% tolerance and low output
ripple and noise.
All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified
Input Specifications
Voltage Range
Input Filter
Input Reflected Ripple Current¹
10%
Capacitor
20 mA pk-pk
Output Specifications
Voltage Accuracy
Short Circuit Protection
Line Regulation
Load Regulation (20% - 100%)
Ripple and Noise (20Mhz bandwidth)
Temperature Coefficient
3%
Short Term
1.2% / 1% Vin Change
10% (3.3 Vout Models: 20%)
75 mV pk-pk
0.02% / °C
General Specifications
Efficiency
See Table
1000 VDC
60 pF, typ.
1000 M Ohm
80 kHz (Variable)
95% rel H
I/O Isolation Voltage (3 sec.)
I/O Isolation Capacity
I/O Isolation Resistance
Switching Frequency
Humidity
Reliability Calculated MTBF (MIL-HDBK-217F) > 1.121 Mhrs
Physical Specifications
Case Material
Potting Material
Weight
Non Conductive Black Plastic (UL94V-0 rated)
Epoxy (UL94V-0 rated)
~ 2.3g, typ.
Environment Specifications
Operating Temperature
Maximum Case Temperature
Storage Temperature
Cooling
-40 to +85°C (ambient)
100°C
-40 to +125°C
Free Air Convection (10 mm distance required)
Soldering 260°C, max. (1.5 mm from case 10s.)
RoHS Conform
PM3-Series – P10CU-xxxxE/Z LF – Single and Dual Output – SIP7 - Plastic Case
Specification can change without a notice – We accept no liability for any inaccuracy or printing errors.
Page 1/4