5秒后页面跳转
捷配首页

Datasheet > OP4009B
OP4009B PDF预览

OP4009B

更新时间： 2024-11-06 10:22:35
品牌 Logo 应用领域
RFM 振荡器输出元件时钟
页数 文件大小 规格书
2页 126K
描述
672.163 MHz Optical Timing Clock

阅读下载

中文翻译

获取价格

OP4009B 数据手册

 浏览型号OP4009B的Datasheet PDF文件第2页 
Preliminary  
OP4009B  
•
•
•
•
Quartz SAW Stabilized and Filtered “Diff Sine” Technology  
Fundamental-Mode Oscillation at 672.163 MHz  
Voltage Tunable for Phase Lock Loop Operations  
672.163 MHz  
Optical  
Timing Clock  
Optical Timing Reference for Forward Error Correction Applications  
The output of this device is generated and filtered by narrowband quartz SAW elements at 672.163 MHz. The  
configuration of this clock is intended to provide a pure signal for optical timing applications in noisy signal  
environments. The Q/Qbar differential output swing of ±1 volt about 0 vdc has symmetry better than ±1% into  
loads from 40 ohms to 70 ohms; determined by customer application. The long term frequency accuracy is  
set by an external reference source allowing this device to complete a Phase Lock Loop design without the  
usual noise and jitter problems associated with PLL’s.  
Absolute Maximum Ratings  
Rating  
Value  
0 to 5.5  
0 to 6  
Units  
VDC  
VDC  
°C  
DC Suppy Voltage  
Tune Voltage  
Case Temperature  
-55 to 100  
SMC-08  
Electrical Characteristics  
Characteristic  
Sym  
Notes  
1, 9  
2
Minimum  
Typical  
Maximum  
Units  
MHz  
ppm  
672.163  
Operating Frequency  
Absolute Frequency  
Tune Range  
f
O
±100  
0
1
Tune Voltage  
+3  
VDC  
1, 8  
2, 10  
±3%  
265  
Tuning Linearity  
140  
125  
0.60  
Tuning Sensitivity  
Modulation Bandwidth  
Voltage into 50 W (VSWR£1.2)  
df/dv  
300  
ppm/V  
kHz  
Q and Q Output  
V
1,3  
1,3  
1.1  
2:1  
V
P-P  
O
Operating Load VSWR  
Symmetry  
3, 4, 5  
3, 4, 6  
3, 4, 6, 7  
49  
51  
-30  
-60  
%
Harmonic Spurious  
Nonharmonic Spurious  
dBc/Hz@100Hz offset  
1kHz offset  
dBc  
dBc  
Phase Noise  
-75  
-105  
-125  
-155  
2
dBc/Hz  
dBc/Hz  
10k offset  
Noise Floor  
3, 4, 6, 7  
3, 4, 6, 7  
3
Q and Q Jitter  
RMS Jitter  
PS  
PS  
PS  
P-P  
P-P  
P-P  
No Noise on V  
12  
CC  
200 mV  
from 1MHz to ½ f on  
12  
P-P  
O
Input Impedence (Tuning Port)  
Output DC Resistance (between Q & Q)  
1
KW  
1, 3  
1, 3  
1, 3  
1, 3  
50  
KW  
VDC  
mA  
DC Power Supply  
3.13  
5.25  
70  
Operating Voltage  
Operating Current  
V
3.3, 5.0  
CC  
I
CC  
Operating Case Temperature  
T
-40°C  
+85°C  
°C  
C
Lid Symbolization (YY=Year, WW=Week)  
RFM OP4009B YYWW  
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. COCOM CAUTION: Approval by the U.S. Department of Commerce is  
required prior to export of this device.  
Notes:  
BLOCK DIAGRAM  
1.  
Unless otherwise noted, all specifications include any combination of load VSWR, Vcc, and temperature, with Q and Q terminated into  
50 ohm loads to ground (see typical test circuit).  
Useful tuning range is in excess of what is required over temp, aging, pushing, pulling & accuracy.  
The design, manufacturing process, and specifications of this device are subject to change without notice.  
Only under the nominal conditions of 50 W load impedance with VSWR £ 1.2 and nominal power supply voltage.  
Symmetry is defined as the pulse width (in percent of total period) measured at the 50% points of Q or Q (see timing definitions).  
Jitter and other spurious outputs induced by externally generated electrical noise on VCC or mechanical vibration are not included in this  
V
CC  
2.  
3.  
4.  
5.  
6.  
Q
_
Q
specification, except where noted. External voltage regulation and careful PCB layout are recommended for optimum performance.  
Applies to period jitter of Q and Q. Measurements are made with the Tektronix CSA803 signal analyzer with at least 1000 samples.  
Linearity is a function of the percentage variation from a permitted linear deviation versus the amount of frequency tune range (see lin-  
earity definition).  
V
tune  
7.  
8.  
SAW Oscillator  
Buffer Amplifier  
9.  
One or more of the following United States patents apply: 4,616,197; 4,670,681; 4,760,352.  
RF Monolithics, Inc.  
RFM Europe  
Phone: (972) 233-2903  
Phone: 44 1963 251383  
Fax: (972) 387-8148  
Fax: 44 1963 251510  
E-mail: info@rfm.com  
http://www.rfm.com  
OP4009B-041003  
Page 1 of 2  
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.  
12

中文翻译

下载PDF

与OP4009B相关器件

型号 品牌 获取价格 描述 数据表
OP400ARPFB MAXWELL

获取价格

 		Operational Amplifier, 4 Func, 270uV Offset-Max, PDFP16, DFP-16
OP400ARPFI MAXWELL

获取价格

 		Operational Amplifier, 4 Func, 270uV Offset-Max, PDFP16, DFP-16
OP400ARPFS MAXWELL

获取价格

 		Operational Amplifier, 4 Func, 270uV Offset-Max, PDFP16, DFP-16
OP400ATC ADI

获取价格

 		Quad Low Offset, Low Power Operational Amplifier
OP-400ATC/883 ADI

获取价格

 		QUAD LOW-OFFSET, LOW-POWER OPERATIONAL AMPLIFIER
OP400ATCMDA ADI

获取价格

 		Quad Low Offset, Low Power Operational Amplifier
OP400AY ADI

获取价格

 		Quad Low-Offset, Low-Power Operational Amplifier
OP-400AY ADI

获取价格

 		QUAD LOW-OFFSET, LOW-POWER OPERATIONAL AMPLIFIER
OP400AY/883C ADI

获取价格

 		IC QUAD OP-AMP, 270 uV OFFSET-MAX, 0.5 MHz BAND WIDTH, CDIP14, HERMETIC SEALED, CERDIP-14,
OP400AYMDA ADI

获取价格

 		Quad Low Offset, Low Power Operational Amplifier

与OP4009B相关文章

您还可以找


热门产品
PCB打样/小批量
铝基板
BOM智能配单
PCBA制造
钣金
精密CNC
模具注塑
薄膜开关
精选活动
PCBA打样特惠
四六层板品质升级
铝基板品质升级
一体化电子制造
DFM下载
服务支持
企业认证
产品展示
工厂展示
工艺能力
积分商城
关于捷配
捷配简介
企业文化
公司动态
人才招聘
联系我们
帮助中心
下单流程
付款流程
开票流程
常见问题
全球PCB制造服务专线 400-613-0088

工作时间：9:00-21:00

CEO邮箱：ceo@jiepei.com

投诉邮箱：tousu@jiepei.com

捷配网-微信公众号 微信公众号
捷配网-微信公众号 抖音公众号
资质认证：
合作快递：
支付方式：
Copyright © 2024 Jiepei.com Inc. All Rights Reserved. 版权所有:杭州捷配信息科技有限公司 浙公网安备 33010502006866号 浙ICP备10014259号-119 营业执照ICP证