5秒后页面跳转
CAT9552WI-T1 PDF预览

CAT9552WI-T1

更新时间: 2024-01-08 02:28:08
品牌 Logo 应用领域
安森美 - ONSEMI 显示驱动器驱动程序和接口接口集成电路光电二极管
页数 文件大小 规格书
17页 169K
描述
16-Channel I2C-bus LED Driver with Programmable Blink Rate

CAT9552WI-T1 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Obsolete零件包装代码:SOIC
包装说明:0.300 INCH, HALOGEN FREE AND ROHS COMPLIANT, MS-013, SOIC-24针数:24
Reach Compliance Code:unknownECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.07
Is Samacsys:N数据输入模式:SERIAL
接口集成电路类型:LED DISPLAY DRIVERJESD-30 代码:R-PDSO-G24
JESD-609代码:e3长度:15.3 mm
湿度敏感等级:3复用显示功能:NO
功能数量:1区段数:16
端子数量:24最高工作温度:85 °C
最低工作温度:-40 °C封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装等效代码:SOP24,.4
封装形状:RECTANGULAR封装形式:SMALL OUTLINE
峰值回流温度(摄氏度):NOT SPECIFIED电源:2.5/5 V
认证状态:Not Qualified座面最大高度:2.65 mm
子类别:Display Drivers最大供电电压:5.5 V
最小供电电压:2.3 V标称供电电压:3 V
表面贴装:YES温度等级:INDUSTRIAL
端子面层:Tin (Sn)端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:7.47 mm
最小 fmax:0.4 MHzBase Number Matches:1

CAT9552WI-T1 数据手册

 浏览型号CAT9552WI-T1的Datasheet PDF文件第2页浏览型号CAT9552WI-T1的Datasheet PDF文件第3页浏览型号CAT9552WI-T1的Datasheet PDF文件第4页浏览型号CAT9552WI-T1的Datasheet PDF文件第5页浏览型号CAT9552WI-T1的Datasheet PDF文件第6页浏览型号CAT9552WI-T1的Datasheet PDF文件第7页 
CAT9552  
16-Channel I2C-bus LED Driver with  
Programmable Blink Rate  
FEATURES  
DESCRIPTION  
„ 16 LED drivers with On/Off and programmable  
The CAT9552 is a 16-channel, parallel input/output  
port expander optimized for LED On/Off and blinking  
control. Each individual LED may be turned ON, OFF,  
or set to blinking at one of two programmable rates.  
The CAT9552 is compatible with I2C and SMBus  
applications where it is desireable to limit the bus  
traffic or free-up the bus master’s internal timer. Three  
address pins allow up to eight CAT9552 devices to  
occupy the same bus.  
blink rate control  
„ 2 selectable, programmable blink rates:  
– frequency: 0.172Hz to 44Hz  
– duty cycle: 0% to 99.6%  
„ 16 open drain outputs drive 25mA each  
„ I/Os can be used as GPIOs  
„ 400kHz I2C bus compatible  
„ 2.3V to 5.5V operation  
The CAT9552 contains an internal oscillator and two  
PWM signals, which drive the LED outputs. The user  
may program the period and duty cycle for each  
individual PWM signal. After an initial set-up command  
to program the Blink Rate 1 and Blink Rate 2 (frequency  
and duty cycle), only one command from the bus master  
is required to turn each individual open drain output ON,  
OFF, or cycle at Blink Rate 1 or Blink Rate 2. Each open  
drain LED output can sink a maximum current of 25mA.  
The total continuous current sunk by all I/Os must not  
exceed 200mA per package.  
„ 5V tolerant I/Os  
„ Active low reset input  
„ RoHS-compliant 24-Lead SOIC, TSSOP and  
24-pad TQFN (4 x 4mm) packages  
APPLICATIONS  
„ Office machines  
„ Appliance control panels  
„ Alarm systems  
TYPICAL APPLICATION CIRCUIT  
„ Point of sale displays  
5 V  
5 V  
For Ordering Information details, see page 16.  
3 x 10k  
RS0  
RS1  
RS11  
V
CC  
SDA  
SDA  
SCL  
LED0  
LED1  
SCL  
RESET  
RESET  
CAT9552  
LED11  
2
I C/SMBus  
Master  
A2  
A1  
A0  
LED12  
GPIOs  
V
LED15  
SS  
Notes: LED0 to LED11 are shown being used as LED drivers  
LED12 to LED15 are used as standard GPIOs  
© 2008 SCILLC. All rights reserved  
Characteristics subject to change without notice  
1
Doc. No. MD-9005 Rev B  

与CAT9552WI-T1相关器件

型号 品牌 描述 获取价格 数据表
CAT9552YI ONSEMI 16-Channel I2C-bus LED Driver with Programmable Blink Rate

获取价格

CAT9552YI ROCHESTER LED DISPLAY DRIVER, PDSO24, 4.40 MM, ROHS COMPLIANT, MO-153, TSSOP-24

获取价格

CAT9552YI-T2 ROCHESTER LED DISPLAY DRIVER, PDSO24, 4.40 MM, ROHS COMPLIANT, MO-153, TSSOP-24

获取价格

CAT9552YI-T2 ONSEMI 16-Channel I2C-bus LED Driver with Programmable Blink Rate

获取价格

CAT9554 ONSEMI 8-bit I²C and SMBus I/O Port with Interrupt

获取价格

CAT9554 CATALYST Catalyst Semiconductor

获取价格