NCP370
Positive and Negative
Overvoltage Protection
with Internal Low RON
N-MOSFETs and Reverse
Charge Control Pin
http://onsemi.com
MARKING
The NCP370 is an overvoltage, overcurrent and reverse control
device. Two main modes are available by setting logic pins. First mode
is Direct Mode from Wall−Adapter to the system. In this mode the
system is both positive and negative over−voltage protected up to
+28 V and down to −28 V. The wall adapter (or AC/DC charger) is
disconnected from the system if the input voltage exceeds the
overvoltage (OVLO) or undervoltage (UVLO) thresholds. At power
DIAGRAM
NCAI
370
1
12 PIN LLGA
MU SUFFIX
CASE 513AK
ALYWG
G
up, the V turns on 30 ms after the V exceeds the undervoltage
threshold.
out
in
A
L
= Assembly Location
= Wafer Lot
The second mode (see Tables 1 & 2), called the Reverse Mode,
allows an external accessory to be powered by the system battery or
boost converter. Here the external accessory would be connected to the
device input (bottom connector of system) and the device battery
would be at the device output. In this case overcurrent protection is
activated to prevent accessory faults and battery discharge. Thanks to
the NCP370 using an internal NMOS, the system cost and the PCB
area of the application board are minimized.
The NCP370 provides a negative going flag (FLAG) output which
alerts the system that a fault has occurred.
In addition, the device has ESD−protected input (15 kV Air) when
bypassed with a 1 mF or larger capacitor.
Y
W
G
= Year
= Work Week
= Pb−Free Package
(Note: Microdot may be in either location)
1
2
3
4
5
6
12
11
IN
IN
NC
OUT
FLAG
DIR
10
9
GND
RES
RES
RES
NCP370
8
REV
Ilim
7
Features
• Overvoltage Protection Up to 28 V
• Negative Voltage Protection Down to −28 V
• Reverse Charge Control: REV
• Direct Charge Control: DIR
• Overcurrent Protection
(Top View)
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 10 of this data sheet.
• Thermal Shutdown
• On−chip Low R
NMOS Transistors: Typical 130 mW
DS(on)
• Overvoltage Lockout (OVLO)
• Undervoltage Lockout (UVLO)
• Soft−Start
Typical Applications
• Alert FLAG Output
• Cell Phones
• Camera Phones
• Digital Still Cameras
• Personal Digital Applications
• MP3 Players
• Compliance to IEC61000−4−2 (Level 4)
8 kV (Contact)
15 kV (Air)
• ESD Ratings: Machine Model = B
Human Body Model = 2
• 12 Lead TLLGA 3x3 mm Package
• This is a Pb−Free Device
© Semiconductor Components Industries, LLC, 2008
1
Publication Order Number:
December, 2008 − Rev. 2
NCP370/D