NCP1910
High Performance Combo
Controller for ATX Power
Supplies
Housed in a SO−24WB package, the NCP1910 combines a
state−of−the−art circuitry aimed to powering next generation of ATX
or flat TVs converters. With a 65 kHz Continuous Conduction Mode
Power Factor Controller and a LLC controller hosting a high−voltage
driver, the NCP1910 is ready to power 85+ types of offline power
supplies. To satisfy stringent efficiency considerations, the PFC circuit
implements an adjustable frequency fold back to reduce switching
losses as the load is going light. To cope with all the signal sequencing
required by the ATX and flat TVs specifications, the controller
includes several dedicated pins enabling handshake between the
secondary and the primary sides. These signals include a power−good
line but also a control pin which turns the controller on and off via an
opto coupler. Safety−wise, a second OVP input offers the necessary
redundancy in case the main feedback network would drift away.
Finally, a fast fault input immediately reacts in presence of an over
current condition by triggering an auto−recovery soft−start sequence.
http://onsemi.com
SO−24WB Less Pin 21
DW SUFFIX
CASE 752AB
MARKING DIAGRAM
NCP1910XXX
AWLYYWWG
1
XXXXX = Specific Device Code
A
= Assembly Location
= Wafer Lot
= Year
= Work Week
= Pb−Free Package
WL
YY
WW
G
Features
• Fixed−Frequency 65 kHz CCM Power Factor Controller
• Average Current−Mode Control for Low Line Distortion
• Dynamic Response Enhancer Reduces Bulk Undershoot
• Independent Over Voltage Protection Sensing Pin with Latch−off
Capability
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 36 of this data sheet.
• Adjustable Frequency Fold Back Improves Light Load Efficiency
• Adjustable Line Brown−out Protection with 50 ms
Delay to Help Meeting Hold−up Time Specifications
• Programmable Over current Threshold Leads to an
Optimized Sensing Resistor
• on/off Control Pin for Secondary−Based Remote
Control
• On−Board 5 V Reference Voltage for Precise
Thresholds/Hysteresis Adjustments
• Power Good Output Management Signal
•
1 A peak Current Drive Capability
• LLC Controller Operates from 25 kHz to 500 kHz
• On Board 600 V High−Voltage Drivers
• 1 A/0.5 A Sink/Source Capability
• A Version with Dual Ground Pinout (No Skip),
B Version with Single Ground and Skip Operation for
the LLC Controller
• 20 V Operation
• These are Pb−Free Devices
• Minimum Frequency Precision Down to 3% Over
Temperature Range
• Internally Fixed Dead−Time Value of 300 ns
Typical Applications
• Adjustable Soft−Start Sequence
• Multi Output ATX Power Supplies (A version)
• Flat TVs Power Supplies (B version)
• Fast Fault Input with Soft−Start Trigger for Immediate
Auto−Recovery Protection
© Semiconductor Components Industries, LLC, 2012
1
Publication Order Number:
December, 2012 − Rev. 1
NCP1910/D