NCP1239
Fixed Frequency
Current‐Mode Controller for
Flyback Converter
The NCP1239 is a fixed-frequency current-mode controller
featuring a high-voltage start-up current source to provide a quick and
lossless power-on sequence. This function greatly simplifies the
www.onsemi.com
design of the auxiliary supply and the V capacitor by activating the
CC
internal start-up current source to supply the controller during start-up,
transients, latch, stand-by etc.
SOIC−7
With a supply range up to 35 V, the controller hosts a jittered 65 or
100-kHz switching circuitry operated in peak current mode control.
When the power on the secondary side starts to decrease, the controller
automatically folds back its switching frequency down to minimum
level of 26 kHz. As the power further goes down, the part enters skip
cycle while limiting the peak current that insures excellent efficiency
in light load condition.
NCP1239 features a timer-based fault detection circuitry that
ensures a quasi-flat overload detection, independent of the input
voltage.
CASE 751U
PIN CONNECTIONS
1
2
3
4
8
HV
Fault
FB
6
5
VCC
DRV
CS
GND
Features
• Fixed-Frequency 65-kHz or 100-kHz Current-Mode Control
Operation
• Frequency Foldback Down to 26 kHz and Skip Mode to
Maximize Performance in Light Load Conditions
• Adjustable Over Power Protection (OPP) Circuit
MARKING DIAGRAM
8
• High-Voltage Current Source with Brown-Out (BO) Detection
• Internal Slope Compensation
1239xfff
ALYWX
G
• Internal Fixed Soft-Start
• Frequency Jittering in Normal and Frequency Foldback Modes
1
• 64-ms Timer-Based Short-Circuit Protection with Auto-Recovery
or Latched Operation
1239xfff = Specific Device Code
• Pre-Short Ready for Latched OCP Versions
x = A, B, C, D, E, F, G, H or I
fff = 065 or 100
= Assembly Location
= Wafer Lot
= Year
= Work Week
• Latched OVP on VCC – Autorecovery for C and E Versions
• Latched OVP/OTP Input for Improved Robustness
A
L
Y
W
G
• 35-V V Operation
CC
•
500 mA Peak Source/Sink Drive Capability
= Pb−Free Package
• Internal Thermal Shutdown
• Extremely Low No-Load Standby Power
ORDERING INFORMATION
• Pin-to-Pin Compatible with the Existing NCP1236/1247 Series
• These Devices are Pb-Free and are RoHS Compliant
See detailed ordering and shipping information on page 25 of
this data sheet.
Typical Applications
• AC-DC Converters for TVs, Set-Top Boxes and Printers
• Offline Adapters for Notebooks and Netbooks
© Semiconductor Components Industries, LLC, 2016
1
Publication Order Number
September, 2016 − Rev. 12
NCP1239/D