MT9074
T1/E1/J1 Single Chip Transceiver
Advance Information
DS5024
ISSUE 5
September 1999
Features
•
Combined E1 (PCM 30) and T1 (D4/ESF) framer,
Line Interface Unit (LIU) and link controller with
optional digital framer only mode
Ordering Information
MT9074AP
MT9074AL
68 Pin PLCC
100 Pin MQFP
•
•
•
In T1 mode the LIU can recover signals attenuated
by up to 36 dB (6000 ft. of 24 AWG cable)
-40°C to 85°C
In E1 mode the LIU can recover signals attenuated
by up to 36 dB (2000 m. of 0.65mm cable)
Description
The MT9074 is a single chip device, operable in
either T1 or E1 mode, integrating either an advanced
T1 (T1 mode) or PCM 30 (E1 mode) framer with a
Line Interface Unit (LIU).
Two HDLCs: FDL and channel 24 in T1 mode,
timeslot 0 (Sa bits) and timeslot 16 in E1 mode
•
•
Two-frame elastic buffer in Rx & Tx (T1) directions
Programmable transmit delay through transmit slip
buffer
The framer interfaces to a 2.048 Mbit/s backplane
providing selectable data link access with optional
HDLC controllers for either the FDL bits and channel
•
•
Low jitter DPLL for clock generation
Enhanced alarms, performance monitoring and
error insertion functions
24 (T1 mode) or S bits and channel 16 (E1 mode).
a
The LIU interfaces the framer to T1 (T1 mode) or
PCM 30 (E1 mode) transformer-isolated four-wire
line with minimal external components required.
•
•
Intel or Motorola non-multiplexed parallel
microprocessor interface
ST-BUS 2.048 Mbit/s backplane bus for both data
and signaling
In T1 mode the MT9074 supports D4, ESF and SLC-
96 formats, meeting the latest recommendations
including ITU I.431, AT&T PUB43801, TR-62411,
ANSI T1.102, T1.403 and T1.408. In E1 mode the
•
•
•
Japan Telecom J1 Framing and Yellow Alarm
Hardware data link access
JTAG Boundary Scan
MT9074
supports
the
latest
ITU-T
Applications
Recommendations including G.703, G.704, G.706,
G.732, G.775, G.796, G.823 for PCM 30, and I.431
for ISDN primary rate. It also supports ETSI ETS 300
011, ETS 300 166 and ETS 300 233.
•
•
•
•
E1/T1 add/drop multiplexers and channel banks
CO and PBX equipment interfaces
Primary Rate ISDN nodes
Digital Cross-connect Systems (DCS)
TxDL TxDLCLK
TxMF
TxAO TxB TxA
DSTi
CSTi
ST-BUS
Interface
Transmit Framing, Error,
Test Signal Generation and Slip Buffer
TTIP
TRING
Line
Driver
Tdi
Tdo
Tms
Tclk
Trst
PL Loop
ST Loop
National
Bit Buffer
S/FR
Jitter Attenuator
& Clock Control
IRQ
BS/LS
OSC1
OSC2
D7~D0
Data Link,
CAS
Buffer
AC4
HDLC0
HDLC1
AC0
DG Loop
R/W/WR
CS
DS/RD
RTIP
RRING
DSTo
CSTo
Receive Framing, Performance Monitoring,
Alarm Detection, 2 Frame Slip Buffer
ST-BUS
Interface
RxDLCLK RxDL RxMF
LOS
RxFP
E1.5o F0b C4b
Figure 1 - Functional Block Diagram
1