MSP430TCH5E
www.ti.com
SLAS895 –DECEMBER 2013
Haptics-Enabled Mixed-Signal Microcontroller
Check for Samples: MSP430TCH5E
1
FEATURES
23
•
Haptics-Enabled Device Authenticated to Run
Immersion TouchSense™ Technology
•
Universal Serial Communication Interface
(USCI)
–
–
Supports 122 Different Haptic Effects
–
Enhanced UART With Automatic Baud Rate
Detection (LIN)
Supports Wide Range of LRA and ERM
Actuators Offering Maximum Design
Flexibility
–
–
–
IrDA Encoder and Decoder
Synchronous SPI
I2C
–
Highly Customizable Haptics Effects:
Multiple-Effect Sequencing, Delays, and
Repeat Counters
•
•
On-Chip Comparator for Analog Signal
Compare Function or Slope Analog-to-Digital
(A/D) Conversion
–
–
Supports Audio Synchronized Haptics
Playout (Audio-to-Haptics)
10-Bit 200-ksps Analog-to-Digital Converter
(ADC) With Internal Reference, Sample-and-
Hold, and Autoscan
Supports Programmable Solution Allowing
Integration With Capacitive Touch and
Other System Controller Functionality
•
•
Brownout Detector
–
With Licenses Included
Serial Onboard Programming,
No External Programming Voltage Needed,
Programmable Code Protection by Security
Fuse
•
Low Supply-Voltage Range: 1.8 V to 3.6 V
Ultra-Low-Power Consumption
•
–
–
–
Active Mode: 230 µA at 1 MHz, 2.2 V
Standby Mode: 0.5 µA
•
On-Chip Emulation Logic With Spy-Bi-Wire
Interface
Off Mode (RAM Retention): 0.1 µA
•
•
Family Members are Summarized in Table 1
•
•
Five Power-Saving Modes
Available in 28-Pin TSSOP and 32-Pin QFN
(RHB) Packages
Ultra-Fast Wake Up From Standby Mode in
Less Than 1 µs
•
For Complete Module Descriptions, see the
MSP430x2xx Family User’s Guide (SLAU144)
•
•
16-Bit RISC Architecture, 62.5-ns Instruction
Cycle Time
Basic Clock Module Configurations
APPLICATIONS
–
Internal Frequencies up to 16 MHz With
Four Calibrated Frequency
•
Touch-Enabled Devices That Require Both
Capacitive Touch and Haptics Solutions
Integrated
–
Internal Very-Low-Power Low-Frequency
(LF) Oscillator
•
•
•
•
•
Portable Gaming Consoles
Portable Navigation Devices
Application Consoles
Tablets
–
–
32-kHz Crystal
External Digital Clock Source
•
•
Two 16-Bit Timer_A With Three
Capture/Compare Registers
Mobile Phones
Up to 24 Capacitive Touch I/O Pins
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
3
MSP430 is a trademark of Texas Instruments.
TouchSense is a trademark of Immersion Corporation.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2013, Texas Instruments Incorporated