Velociti™ Series
MM0-6RF
Multi-Mod Relay
Output Module
Description
The FCI Velociti™ Series, multi-mod six relay output
module (MMO-6RF) provides six (6), Form “C” control
relay outputs on one board. Its compact design affords
ease of installation while using a minimum of wall space.
The VelocitiTM Series use a communication protocol that
substantially increases the speed of communication be-
tween the sensors and certain FCI analog addressable
fire alarm controls. These devices operate in a grouped
fashion. If one of the devices in the group has a status
change, the panel’s microprocessor stops the group poll
and concentrates on the single device. The net effect is
response speed up to five times greater than earlier de-
signs.
MMO-6RF
The MMO-6RF connects to the signaling line circuit
(SLC) of the FCI analog addressable series fire alarm
control panels. Each relay circuit on the MMO-6RF occu-
pies its own address on the control panel’s SLC and can
be programmed to respond to its own individual control-
by-event sequence of operation. The address of the first
relay is set by a pair of rotary code switches on the
MMO-6RF. Each remaining relay circuit is automatically
assigned to its own subsequent address.
Features
• Each module provides six (6), individually addressed,
individually programmable form “C” relays.
• Removable wiring terminal blocks allow ease of
installation and servicing.
The MMO-6RF module includes an address disable
switch that allows one, two, or three addresses to be
turned off to free these addresses for other purposes.
• Terminal blocks can accommodate 12 to 18 AWG wire.
• Flexible jumper configuration feature allowing up to
three relay addresses to be disabled.
• A wide range of contact ratings.
• Designed for FCI analog addressable series fire
alarm control panels.
Each relay has its own status LED that flashes to indi-
cate proper polling and lights steady when the circuit has
been activated.
• Individual LED indicators*.
• Suitable for retrofit applications.
Two (2), multi-mod series units can be mounted in one
MBB-2 cabinet. Additional mounting options include the
MCH-6 chassis that can accommodate six (6), multi-mod
series modules. The MCH-6 chassis can be installed in
custom cabinets or mounted in the MBB-6 cabinet.
• Ideal for applications such as elevator control, AHU
control, door holder release or similar functions
requiring multiple relay outputs.
• Two (2), mounting cabinets available for two (2),
(MBB-2 cabinet) to six (6), (MBB-6 cabinet) units.
Note: Only the red LED is operative in panels that do not oper-
ate in Velociti™ mode.
The multi-mod series is ideal for applications where cen-
tralized location of circuits is required. As many as thirty-
six (36), Form “C” relays may be located in a cabinet that
is only 12.63” H x 24” W x 6.5” D in dimension saving
valuable wall space in mechanical rooms and electrical
closets and reducing cost of installation.
An ISO 9001-2000 Company
Velociti™ and E3 Series™ are trademarks of Fire Control Instruments.
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472 - Tel: (203) 484-7161 - Fax: (203) 484-7118
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
©2006 Gamewell-FCI. All rights reserved.
www.gamewell-fci.com
9020-0632 Rev. B page 1 of 2