NXP Semiconductors
Data Sheet: Technical Data
KV4XP100M168
Rev. 3, 06/2016
KV4x Data Sheet
MKV46FxxxVLy16
MKV44FxxxVLy16
MKV42FxxxVLy16
168 MHz ARM Cortex-M4 core based Microcontroller with
FPU
The Kinetis KV4x MCU family is a member of the Kinetis V
series and provides a high-performance solution for motor
control and Digital Power Conversion. Built upon the ARM®
Cortex®-M4 core operating at up to 168 MHz with DSP and
floating point unit, features include; dual 12-bit analog-to-digital
converters with 240ns conversion time, up to 30 PWM channels
for support of multi-motor systems, eFlexPWM module with 312
ps resolution for digital power conversion applications,
programmable delay block, memory protection unit, dual
FlexCAN modules and 64 to 256 KB of flash memory. KV4x
MCUs are offered in 48LQFP, 64LQFP, and 100LQFP
packages. All Kinetis V series MCUs are supported by a
comprehensive enablement suite from NXP and third-party
resources including reference designs, software libraries and
100 LQFP
64 LQFP
14 x 14 x 1.4 Pitch 0.5 10 x 10 x 1.4 Pitch 0.5
mm
mm
48 LQFP
7 x 7 x 1.4 Pitch 0.5 mm
motor configuration tools. KV4x MCUs are enabled to support Kinetis Motor Suite (KMS), a bundled hardware
and software solution that enables rapid configuration of BLDC and PMSM motor drive systems.
Core
• ARM® Cortex®-M4 core up to 168 MHz with single
precision Floating Point Unit (FPU)
Communication interfaces
• Two Universal Asynchronous Receiver/Transmitter
(UART) / FlexSCI modules with programmable 8- or
9-bit data format
Memories
• One 16-bit SPI module
• Up to 256 KB of program flash memory
• Up to 32 KB of RAM
• One I2C module
• Two FlexCAN modules
System peripherals
Analog Modules
• 16-channel DMA controller
• Low-leakage wakeup unit
• SWD interface and Micro Trace buffer
• Advanced independent clocked watchdog
• Two 12-bit cyclic ADCs
• Four analog comparator (CMP) containing a 6-bit
DAC and programmable reference input
• One 12-bit DAC
Clocks
Timers
• 32 to 40 kHz or 3 to 32 MHz crystal oscillator
• Multipurpose clock generator (MCG) with frequency-
locked loop and phase-locked loop referencing either
internal or external reference clock
• One eFlexPWM with 4 sub-modules, providing 12
PWM outputs
• Two 8-channel FlexTimers (FTM0 and FTM3)
• One 2-channel FlexTimers (FTM1)
• Four Periodic interrupt timers (PIT)
• Two Programmable Delay Blocks (PDB)
• Quadrature Encoder/Decoder (ENC)
• Ratio of timer input clock frequency vs. core
frequency is 1:2 when core frequency is 168 Mhz,
and 1:1 when core frequency is less than or equal to
100 Mhz
Operating Characteristics
• Voltage range: 1.71 to 3.6 V
• Temperature range: –40 to 105 °C
Human-machine interface
• General-purpose input/output
NXP reserves the right to change the production detail specifications as may be
required to permit improvements in the design of its products.