MIC33M350
3A, Pin Strapping Power Module
with HyperLight Load® Mode and Output Voltage Select
Features
General Description
The MIC33M350 device is a pin-selectable output
voltage, high-efficiency, low-voltage input, 3A current,
synchronous step-down regulator power module with
integrated inductor. The Constant On-Time (COT)
control architecture with HyperLight Load provides very
high efficiency at light loads, while maintaining an
ultra-fast transient response.
• 2.4V to 5.5V Input Voltage Range
• 3A Output Current
• Pin Strapping Voltage Selection:
- Three-state pins (nine voltage combinations)
- 0.6V, 0.8V, 0.9V, 1.0V, 1.2V, 1.5V, 1.8V, 2.5V
or 3.3V output voltage
• Passes Automotive AEC-Q104 Reliability Testing
The MIC33M350 output voltage is set by two VSEL
(Voltage Selection) pins, between nine different values.
This method eliminates the need for an external
feedback resistor divider and improves the output
voltage setting accuracy.
• Reduced Component Count (no feedback
resistors)
• High Efficiency (up to 95%)
• Output Discharge when Disabled
• Constant On-Time Control with High Switching
Frequency:
The 2.4V to 5.5V input voltage range, low shutdown
and quiescent currents make the MIC33M350 device
ideal for single cell Li-Ion battery-powered applications.
The 100% duty cycle capability provides Low Dropout
operation, extending operating range in portable
systems.
- 1.2 MHz typical at 1.0V output voltage
• ±1.5% Output Voltage Accuracy Over
Line/Load/Temperature Range
• 0.8 ms/V Soft Start Speed
• Supports Safe Start-up with Pre-Biased Output
• Typical 1.5 µA Shutdown Supply Current
• Low Dropout Operation (100% duty cycle)
• Ultra Fast Transient Response
The MIC33M350 pinout is compatible with the
MIC33M356 I2C-based programmable regulator
version, such that applications can be easily converted.
An open-drain Power Good output is provided to
indicate when the output voltage is within 9% of
regulation and facilitates the interface with an MCU. If
set in shutdown (EN = GND), the MIC33M350 typically
draws 1.5 µA, while the output is discharged through
10pull-down.
• Latch-Off Thermal Shutdown Protection
• Latch-Off Current Limit Protection
• Power Good (PG) Open-Drain Output
• Meets CISPR32 Class B Radiated EMI
• Meets CISPR 25 Class 5 Radiated EMI
MIC33M350 is available in a thermally efficient
package: 24-Lead 3.0 mm x 4.5 mm x 1.8 mm QFN
package, with an operating junction temperature range
from -40°C to +125°C.
• Package: 3.0 mm × 4.5 mm × 1.8 mm,
24-Lead QFN
Applications
MIC33M350 passes Automotive AEC-Q104 Reliability
Testing.
• Solid State Drives (SSD)
• Tablets, Netbooks and Ultrabooks
• FPGAs, DSP and Low-Voltage ASIC Power
Horizontal Polarization
Vertical Polarization
FIGURE 1:
CISPR32, Class B (V = 5V, V
Radiated Emissions,
= 1V,
IN
OUT
I
= 3A).
OUT
2020-2021 Microchip Technology Inc.
DS20006348B-page 1