MIC3003GFL
FOM Management IC
with Internal Calibration
General Description
Features
• Packaged in a ultra small (3mm x 3mm) 24-pin MLF®
The MIC3003GFL is a fiber optic module controller which
enables the implementation of sophisticated, hot-pluggable
fiber optic transceivers with intelligent laser control and an
internally calibrated Digital Diagnostic Monitoring Interface
per SFF-8472. It essentially integrates all non-data path
functions of an SFP/SFP+ transceiver into a tiny (3mm x 3mm)
MLF® package. It also works well as a microcontroller
peripheral in transponders or 10Gbps transceivers. The
MIC3003GFL uses the same die as the MIC3003 with all its
functions, but in a smaller package and different pin out.
package
• Extended temperature range
• Alarms and warnings interrupt and TXFAULT masks
• Capability to support up to four devices on one SMBus
• APC or constant-current laser bias
• Turbo mode for APC loop start-up and shorter laser turn
on time
• Supports multiple laser types and bias circuit topologies
• Integrated digital temperature sensor
A highly configurable automatic power control (APC) circuit
controls laser bias. Bias and modulation are temperature
compensated using dual DACs, an on-chip temperature
sensor, and NVRAM look-up tables. A programmable
internal feedback resistor provides a wide dynamic range for
the APC. Controlled laser turn-on.
• Temperature compensation of modulation, bias, bias fault
and alarm thresholds via NVRAM look-up tables
• NVRAM to support GBIC/SFP serial ID function
• User writable EEPROM scratchpad
An analog-to-digital converter converts the measured
temperature, voltage, bias current, transmit power, and
received power from analog to digital. An EEPOT provides
front-end adjustment of RX power. Each parameter is
compared against user-programmed warning and alarm
thresholds. Analog comparators and DACs provide fast
monitoring of received power and critical laser operating
parameters. Data can be reported as either internally
calibrated or externally calibrated.
• Reset signal compatible with some new systems
requirements
• Diagnostic monitoring interface per SFF-8472
–
Monitors and reports critical parameters:
temperature, bias current, TX and RX optical power,
and supply voltage
–
S/W control and monitoring of TXFAULT, RXLOS,
RATESELECT, and TXDISABLE
An interrupt output, power-on hour meter, and data-ready
bits add user friendliness beyond SFF-8472. The interrupt
output and data-ready bits reduce overhead in the host
system. The power-on hour meter logs operating hours
using an internal real-time clock and stores the result in
NVRAM.
–
–
Internal or external calibration
EEPOT for adjusting RX power measurement
• Power-on hour meter
• Interrupt capability
• Extensive test and calibration features
• 2-wire SMBus-compatible serial interface
• SFP/SFP+ MSA and SFF-8472 compliant
• 3.0V to 3.6V power supply range
• 5V-tolerant I/O
In addition to the features listed above, the MIC3003
features an extended temperature range, options to mask
alarms and warnings interrupt and TXFAULT, a reset signal
source, and the ability to support up to four chips with the
same address on the serial interface. It also supports eight-
byte SMBus block writes.
Applications
Communication with the MIC3003 is via an industry
standard 2-wire SMBus serial interface. Nonvolatile
memory is provided for serial ID, configuration, and
separate OEM and user scratchpad spaces.
• SFP/SFP+ optical transceivers
• SONET/SDH transceivers and transponders
• Fibre Channel transceivers
• 10Gbps transceivers
Datasheets and support documentation can be found on
Micrel’s web site at: www.micrel.com.
• Free space optical communications
• Proprietary optical links
MLF and MicroLeadFrame are registered trademarks of Amkor Technology, Inc.
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
M9999-072910-A
hbwhelp@micrel.com or (408) 955-1690
July, 2010
5秒后页面跳转
解析光耦仿真器：升级光耦合器技术的必要性
英伟达新一代Blackwell GPU过热问题致交付延迟
国产厂商思特威CMOS图像传感器芯片单月出货超1亿颗，技术创新引领行业发展
台积电5nm和3nm产能利用率达100%，半导体行业景气度持续攀升
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
