3U CompactPCI Pentium M 2.0G
High-performance Controller
MIC-3321
Features
NEW
. Built-in Intel® Pentium® M 760 2.0G processor with 2 MB L2 Cache
. Mobile Intel 915GM express chipset
. Supports up to 1GB DDR2 533/400 SDRAM soldered on board
. Extended operating temp: -25 ~ 70° C (Optional: MIC-3321C only)
. Dual Giga LAN on PCI-Express
. High-performance Intel Graphics Media Accelerator 900 VGA display
. Onboard CompactFlash® disk socket
. Onboard 2.5" HDD support
. Rear I/O signal support for easy wiring
Introduction
The MIC-3321 3U is a CompactPCI system controller board that combines the performance of Intel’s Mobile Pentium M 760 2.0GHz processor with the high integration of the 915GM
chipset and the I/O Controller Hub ICH6. The low power of the Intel Mobile Celeron® M makes it possible to work with high extended temperature ranges. The directed soldered CPU
and memory provide less weight and a higher shock/vibration resistance than socket devices.
MIC-3321 is a powerful 3U CompactPCI Controller that fulfills your requirements in mission critical applications, such as military defense, transportation, traffic control, test and
measurement (T&M) as well as critical data acquisition & control applications.
Specifications
MIC-3321: Intel Pentium M 760 2.0 GHz with 2
Interface: RS-232
Controller: 2 x 16C550 Compatible
Data Bits: 5, 6, 7, 8
MB
L2 cache
CPU
MIC-3321C: Intel Celeron M Ultra Low Voltage
373
Stop Bits: 1, 1.5, 2
1.0 GHz with 512 KB L2 cache
Intel 915 GM (GMCH) + Intel 82801FBM (ICH6-
M)
Parity: None, Even, Odd
Speed (bps): 50 ~ 115.2K
Serial
Chipset
BIOS
Award 4 MB Flash
Data Signal: TxD, RxD, RTS, CTS, DTR, DSR,
DCD, RI, GND
533 MHz (Intel Pentium M 760 2.0 GHz CPU)
400 MHz (Intel Celeron M Ultra Low Voltage 373
1.0 GHz CPU)
Front Side Bus
PCI Bus
Connector: 2 x DB9 male
Bus
PCI-to-PCI Bridge: PERICOM PI7C8150
7 x 32bit/33MHz CompactPCI bus Master interface
3.3 V/5 V VIO adjustable
Two as front I/O, one as rear I/O
One channel P-IDE
Supports PIO mode 4 (16.67MB/s data transfer
rate) and ATA 33/66/100
P-IDE
Memory
Graphics
Directed Soldered 512 MB DDR2 SDRAM
Controller: Intel Graphics Media Accelerator 900
VRAM: DVMT3.0 128MB
(33/66/100MB/s data transfer rate)
1 x CompactFlash Socket Type II
1 x 44-pin 2.5" HDD connector
Resolution: Up to 2048 x 1536 with 32-bit color
at 75 Hz
SATA interface with data transfer rate up to
150MB/s
1 x External SATA connector
4 x USB 2.0 channels up to 480Mbps, 2 as front
I/O, 2 as rear I/O
PS/2 for keyboard and mouse legacy support
0 ~ 64s, 0.25s step, generate reset signal
SATA
USB
Interface: 10/100/1000Base-TX Gigabit Ethernet
Controller: 2 x Intel 82573E/L PCI Express Gigabit
Ethernet Controller
Ethernet
PS/2
Watchdog Timer
Connector: 2 x RJ-45
Supports Pre-boot Execution Environment (PXE)
Support for all signals to allow peripheral boards
to be hot swapped. The individual clocks for
each slot and access to the backplane ENUM#
signal comply with the PICMG 2.1 Hot Swap
specification. (PCI to PCI bridge GPIO3)
Hot Swap
CompactPCI Systems