Order this document
by MBRF1045/D
SEMICONDUCTOR TECHNICAL DATA
The SWITCHMODE Power Rectifier employs the Schottky Barrier principle in
a large area metal–to–silicon power diode. State–of–the–art geometry features
epitaxial construction with oxide passivation and metal overlay contact. Ideally
suited for use as rectifiers in very low–voltage, high–frequency switching power
supplies, free wheeling diodes and polarity protection diodes.
Motorola Preferred Device
SCHOTTKY BARRIER
RECTIFIER
•
•
•
•
•
Highly Stable Oxide Passivated Junction
Very Low Forward Voltage Drop
High Junction Temperature Capability
High dv/dt Capability
Excellent Ability to Withstand Reverse Avalanche Energy
Transients
10 AMPERES
45 VOLTS
•
•
•
•
Guardring for Stress Protection
Epoxy Meets UL94, VO at 1/8″
Electrically Isolated. No Isolation Hardware Required.
(1)
UL Recognized File #E69369
1
2
1
2
Mechanical Characteristics
•
•
•
Case: Epoxy, Molded
Weight: 1.9 grams (approximately)
Finish: All External Surfaces Corrosion Resistant and Terminal
Leads are Readily Solderable
CASE 221E–01
ISOLATED TO–220
•
Lead Temperature for Soldering Purposes: 260°C Max. for 10
Seconds
•
•
Shipped 50 units per plastic tube
Marking: B1045
MAXIMUM RATINGS
Rating
Symbol
Value
Unit
Peak Repetitive Reverse Voltage
Working Peak Reverse Voltage
DC Blocking Voltage
V
V
45
Volts
RRM
RWM
R
V
Average Rectified Forward Current (Rated V ), T = 135°C
I
F(AV)
10
20
Amps
Amps
R
C
Peak Repetitive Forward Current
I
FRM
(Rated V , Square Wave, 20 kHz), T = 135°C
R
C
Non–repetitive Peak Surge Current
I
150
Amps
FSM
(Surge applied at rated load conditions halfwave, single phase, 60 Hz)
Peak Repetitive Reverse Surge Current (2.0 µs, 1.0 kHz) Figure 6
Operating Junction and Storage Temperature
I
1.0
Amp
°C
RRM
T , T
J
– 65 to +150
10000
stg
Voltage Rate of Change (Rated V )
dv/dt
V/µs
Volts
R
(2)
RMS Isolation Voltage (t = 1 second, R.H. ≤ 30%, T = 25°C)
Per Figure 8
Per Figure 9
Per Figure 10
V
V
V
4500
3500
1500
A
iso1
iso2
iso3
(1)
THERMAL CHARACTERISTICS
Maximum Thermal Resistance, Junction to Case
R
4.0
°C/W
°C
θJC
Lead Temperature for Soldering Purposes: 1/8″ from Case for 5 seconds
T
260
L
(1) UL Recognized mounting method is per Figure 9.
(2) Proper strike and creepage distance must be provided.
SWITCHMODE is a trademark of Motorola, Inc.
Preferred devices are Motorola recommended choices for future use and best overall value.
Rev 1
Rectifier Device Data
1
Motorola, Inc. 1996