5秒后页面跳转
MAX9969ADCCQ-TD PDF预览

MAX9969ADCCQ-TD

更新时间: 2024-10-31 13:00:23
品牌 Logo 应用领域
美信 - MAXIM 驱动器比较器
页数 文件大小 规格书
31页 688K
描述
Analog Circuit, 1 Func, PQFP100, 14 X 14 MM, 1 MM HEIGHT, TQFP-100

MAX9969ADCCQ-TD 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
零件包装代码:QFP包装说明:14 X 14 MM, 1 MM HEIGHT, TQFP-100
针数:100Reach Compliance Code:not_compliant
HTS代码:8542.39.00.01风险等级:5.66
模拟集成电路 - 其他类型:ANALOG CIRCUITJESD-30 代码:S-PQFP-G100
JESD-609代码:e0长度:14 mm
负电源电压最大值(Vsup):-5.25 V负电源电压最小值(Vsup):-4.5 V
标称负供电电压 (Vsup):-4.75 V功能数量:1
端子数量:100最高工作温度:70 °C
最低工作温度:封装主体材料:PLASTIC/EPOXY
封装代码:TFQFP封装形状:SQUARE
封装形式:FLATPACK, THIN PROFILE, FINE PITCH峰值回流温度(摄氏度):NOT SPECIFIED
认证状态:Not Qualified座面最大高度:1.2 mm
最大供电电压 (Vsup):10.5 V最小供电电压 (Vsup):9.5 V
标称供电电压 (Vsup):9.75 V表面贴装:YES
温度等级:COMMERCIAL端子面层:Tin/Lead (Sn/Pb)
端子形式:GULL WING端子节距:0.5 mm
端子位置:QUAD处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:14 mmBase Number Matches:1

MAX9969ADCCQ-TD 数据手册

 浏览型号MAX9969ADCCQ-TD的Datasheet PDF文件第2页浏览型号MAX9969ADCCQ-TD的Datasheet PDF文件第3页浏览型号MAX9969ADCCQ-TD的Datasheet PDF文件第4页浏览型号MAX9969ADCCQ-TD的Datasheet PDF文件第5页浏览型号MAX9969ADCCQ-TD的Datasheet PDF文件第6页浏览型号MAX9969ADCCQ-TD的Datasheet PDF文件第7页 
19-3389; Rev 0; 8/04  
Dual, Low-Power, 1200Mbps ATE  
Driver/Comparator with 35mA Load  
General Description  
Features  
Low-Power Dissipation: 1.4W/Channel (typ)  
The MAX9969 dual, low-power, high-speed, pin elec-  
tronics driver/comparator with 35mA load IC includes,  
for each channel, a three-level pin driver, a dual com-  
parator, variable clamps, and an active load. An addi-  
tional differential comparator allows comparisons  
between the two channels. The driver features a wide  
voltage range and high-speed operation, includes high-  
impedance and active-termination (3rd-level drive)  
modes, and is highly linear even at low voltage swings.  
The dual comparator provides low dispersion (timing  
variation) over a wide variety of input conditions, and  
differential outputs. The clamps provide damping of  
high-speed device-under-test (DUT) waveforms when  
the device is configured as a high-impedance receiver.  
The programmable load supplies up to 35mA of source  
and sink current. The load facilitates contact/continuity  
testing, at-speed parametric testing of IOH and IOL,  
and pullup of high-output-impedance devices. The  
MAX9969A features tighter matching of offset for the  
drivers and the comparators.  
Greatly Reduced Power Penalty when Load  
Commutated  
High Speed: 1200Mbps at 3V  
and 1800Mbps  
P-P  
at 1V  
P-P  
Programmable 35mA Active-Load Current  
Low Timing Dispersion  
Wide -1.5V to +6.5V Operating Range  
Active Termination (3rd-Level Drive)  
Low-Leakage Mode: 15nA  
Integrated Clamps  
Integrated Differential Comparator  
Interfaces Easily with Most Logic Families  
Digitally Programmable Slew Rate  
Internal Termination Resistors  
Low Offset Error  
The MAX9969 provides high-speed, differential control  
inputs with optional internal termination resistors that  
are compatible with LVPECL, LVDS, and GTL. Flexible  
open-collector outputs with optional internal pullup  
resistors are available for the comparators. These fea-  
tures significantly reduce the discrete component count  
on the circuit board.  
Pin Compatible with the MAX9967  
Ordering Information  
PART  
TEMP RANGE  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
0°C to +70°C  
PIN-PACKAGE  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
100 TQFP-EPR**  
MAX9969ADCCQ  
MAX9969AGCCQ*  
MAX9969ALCCQ  
MAX9969ARCCQ*  
MAX9969BDCCQ  
MAX9969BGCCQ*  
MAX9969BLCCQ  
MAX9969BRCCQ  
A 3-wire, low-voltage, CMOS-compatible serial inter-  
face programs the low-leakage, slew-rate limit, and tri-  
state/terminate operational configurations of the  
MAX9969.  
The MAX9969’s operating range is -1.5V to +6.5V with  
power dissipation of only 1.4W per channel. The device  
is available in a 100-pin, 14mm x 14mm body, and  
0.5mm pitch TQFP. An exposed 8mm x 8mm die pad  
on the top of the package facilitates efficient heat  
removal. The device is specified to operate with an  
internal die temperature of +60°C to +100°C, and fea-  
tures a die temperature monitor output.  
*Future product—contact factory for availability.  
**EPR = Exposed pad reversed (TOP).  
Applications  
High-Performance Mixed-Signal/  
System-on-Chip ATE  
High-Performance Memory ATE  
Pin Configuration and Selector Guide appear at end of data sheet.  
________________________________________________________________ Maxim Integrated Products  
1
For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642,  
or visit Maxim's website at www.maxim-ic.com.  

与MAX9969ADCCQ-TD相关器件

型号 品牌 获取价格 描述 数据表
MAX9969AGCCQ MAXIM

获取价格

Dual, Low-Power, 1200Mbps ATE Driver/Comparator with 35mA Load
MAX9969ALCCQ MAXIM

获取价格

Dual, Low-Power, 1200Mbps ATE Driver/Comparator with 35mA Load
MAX9969ALCCQ+TD MAXIM

获取价格

Analog Circuit, 1 Func, PQFP100, 14 X 14 MM, 1 MM HEIGHT, LEAD FREE, TQFP-100
MAX9969ALCCQ-D MAXIM

获取价格

Analog Circuit, 1 Func, PQFP100, 14 X 14 MM, 1 MM HEIGHT, TQFP-100
MAX9969ALCCQ-T MAXIM

获取价格

Interface Circuit, BIPolar, PQFP100
MAX9969ALCCQ-TD MAXIM

获取价格

Analog Circuit, 1 Func, PQFP100, 14 X 14 MM, 1 MM HEIGHT, TQFP-100
MAX9969ARCCQ MAXIM

获取价格

Dual, Low-Power, 1200Mbps ATE Driver/Comparator with 35mA Load
MAX9969BDCCQ MAXIM

获取价格

Dual, Low-Power, 1200Mbps ATE Driver/Comparator with 35mA Load
MAX9969BDCCQ+TD MAXIM

获取价格

Analog Circuit, 1 Func, PQFP100, 14 X 14 MM, 1 MM HEIGHT, LEAD FREE, TQFP-100
MAX9969BDCCQ-D MAXIM

获取价格

Analog Circuit, 1 Func, PQFP100, 14 X 14 MM, 1 MM HEIGHT, TQFP-100