MAX9967BGCCQ

更新时间： 2024-10-31 04:41:31

品牌	Logo	应用领域
美信 - MAXIM		驱动器比较器
页数	文件大小	规格书
30页	664K
描述
Dual, Low-Power, 500Mbps ATE Driver/Comparator with 35mA Load

阅读下载

中文翻译

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

MAX9967BGCCQ 技术参数

是否Rohs认证：	不符合	生命周期：	Obsolete
零件包装代码：	QFP	包装说明：	14 X 14 MM, 1 MM HEIGHT, 0.50 MM PITCH, TQFP-100
针数：	100	Reach Compliance Code：	not_compliant
ECCN代码：	EAR99	HTS代码：	8542.39.00.01
风险等级：	5.17	放大器类型：	COMPARATOR
最大平均偏置电流 (IIB)：	25 µA	最大输入失调电压：	100000 µV
JESD-30 代码：	S-PQFP-G100	JESD-609代码：	e0
长度：	14 mm	湿度敏感等级：	3
负供电电压上限：	-7 V	标称负供电电压 (Vsup)：	-5.25 V
功能数量：	2	端子数量：	100
最高工作温度：	70 °C	最低工作温度：
输出类型：	OPEN-COLLECTOR	封装主体材料：	PLASTIC/EPOXY
封装代码：	HTFQFP	封装形状：	SQUARE
封装形式：	FLATPACK, HEAT SINK/SLUG, THIN PROFILE, FINE PITCH	峰值回流温度（摄氏度）：	245
认证状态：	Not Qualified	标称响应时间：	2.2 ns
座面最大高度：	1.2 mm	子类别：	Comparator
供电电压上限：	11.5 V	标称供电电压 (Vsup)：	9.75 V
表面贴装：	YES	技术：	BIPOLAR
温度等级：	COMMERCIAL	端子面层：	Tin/Lead (Sn/Pb)
端子形式：	GULL WING	端子节距：	0.5 mm
端子位置：	QUAD	处于峰值回流温度下的最长时间：	NOT SPECIFIED
宽度：	14 mm	Base Number Matches：	1

MAX9967BGCCQ 数据手册

19-3195; Rev 1; 2/05

Dual, Low-Power, 500Mbps ATE

Driver/Comparator with 35mA Load

General Description

Features

The MAX9967 dual, low-power, high-speed, pin electron-

ics driver/comparator/load (DCL) IC includes, for each

channel, a three-level pin driver, a dual comparator, vari-

able clamps, and an active load. The driver features a

wide voltage range and high-speed operation, includes

high-impedance and active-termination (3rd-level drive)

modes, and is highly linear even at low-voltage swings.

The dual comparator provides low dispersion (timing

variation) over a wide variety of input conditions. The

clamps provide damping of high-speed device-under-

test (DUT) waveforms when the device is configured as a

high-impedance receiver. The programmable load sup-

plies up to 35mA of source and sink current. The load

facilitates contact/continuity testing, at-speed parametric

testing of IOH and IOL, and pullup of high-output-imped-

ance devices.

♦ Low Power Dissipation: 1.15W/Channel (typ)

♦ High Speed: 500Mbps at 3V

P-P

♦ Programmable 35mA Active-Load Current

♦ Low Timing Dispersion

♦ Wide -1.5V to +6.5V Operating Range

♦ Active Termination (3rd-Level Drive)

♦ Low Leakage Mode: 60nA

♦ Integrated Clamps

♦ Interfaces Easily with Most Logic Families

♦ Integrated PMU Connection

♦ Digitally Programmable Slew Rate

♦ Internal Termination Resistors

♦ Low Gain and Offset Error

The MAX9967A provides tight matching of gain and off-

set for the drivers, and offset for the comparators and

active load, allowing reference levels to be shared

across multiple channels in cost-sensitive systems. Use

the MAX9967B for system designs that incorporate

independent reference levels for each channel.

Ordering Information

The MAX9967 provides high-speed, differential control

inputs with optional internal termination resistors that

are compatible with ECL, LVPECL, LVDS, and GTL.

ECL/LVPECL or flexible open-collector outputs with

optional internal pullup resistors are available for the

comparators. These features significantly reduce the

discrete component count on the circuit board.

PART

TEMP RANGE

0°C to +70°C

PIN-PACKAGE

100 TQFP-EPR**

MAX9967ADCCQ*

MAX9967AGCCQ*

MAX9967ALCCQ

MAX9967AMCCQ*

MAX9967AQCCQ*

MAX9967ARCCQ*

MAX9967BDCCQ

MAX9967BGCCQ

MAX9967BLCCQ

MAX9967BMCCQ

MAX9967BQCCQ*

MAX9967BRCCQ

A 3-wire, low-voltage, CMOS-compatible serial interface

programs the low-leakage, slew-rate limit, and tri-

state/terminate operational configurations of the

MAX9967.

The MAX9967’s operating range is -1.5V to +6.5V with

power dissipation of only 1.15W per channel. The

device is available in a 100-pin, 14mm x 14mm body,

and 0.5mm pitch TQFP. An exposed 8mm x 8mm die

pad on the top of the package facilitates efficient heat

removal. The device is specified to operate with an

internal die temperature of +70°C to +100°C, and

features a die temperature monitor output.

*Future product—contact factory for availability.

**EPR = Exposed pad reversed (TOP).

Pin Configuration and Typical Application Circuits appear at

end of data sheet.

Selector Guide appears at end of data sheet.

Applications

Low-Cost Mixed-Signal/System-on-Chip ATE

Commodity Memory ATE

PCI or VXI Programmable Digital Instruments

________________________________________________________________ Maxim Integrated Products

For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at

1-888-629-4642, or visit Maxim’s website at www.maxim-ic.com.

12 3 4 5 6 7...30

中文翻译

下载PDF

与MAX9967BGCCQ相关器件

型号	品牌	获取价格	描述	数据表
MAX9967BGCCQ+TD	MAXIM	获取价格	Comparator, 2 Func, 100000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM
MAX9967BGCCQ-TD	MAXIM	获取价格	Comparator, 2 Func, 100000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM
MAX9967BLCCQ	MAXIM	获取价格	Dual, Low-Power, 500Mbps ATE Driver/Comparator with 35mA Load
MAX9967BMCCQ	MAXIM	获取价格	Dual, Low-Power, 500Mbps ATE Driver/Comparator with 35mA Load
MAX9967BMCCQ+D	MAXIM	获取价格	Comparator, 2 Func, 100000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM
MAX9967BMCCQ-D	MAXIM	获取价格	Comparator, 2 Func, 100000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM
MAX9967BMCCQ-TD	MAXIM	获取价格	Comparator, 2 Func, 100000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM
MAX9967BQCCQ	MAXIM	获取价格	Dual, Low-Power, 500Mbps ATE Driver/Comparator with 35mA Load
MAX9967BRCCQ	MAXIM	获取价格	Dual, Low-Power, 500Mbps ATE Driver/Comparator with 35mA Load
MAX9967BRCCQ+D	MAXIM	获取价格	Comparator, 2 Func, 100000uV Offset-Max, 2.2ns Response Time, BIPolar, PQFP100, 14 X 14 MM

与MAX9967BGCCQ相关文章

三星深化印度制造布局，供应链本地化进程加速
2024-10-29

20
芯擎科技“星辰一号”自动驾驶芯片点亮成功，2025年量产在即
2024-10-29

21
纳微科技震撼发布GaNSlim革新氮化镓功率芯片
2024-10-18

45
意法半导体发布第四代SiC技术，助力电动汽车电驱
2024-10-15

53

产品中心

服务支持

精选活动

关于我们

帮助中心

MAX9967BGCCQ

MAX9967BGCCQ 技术参数

MAX9967BGCCQ 数据手册

与MAX9967BGCCQ相关器件

与MAX9967BGCCQ相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

MAX9967BGCCQ

MAX9967BGCCQ 技术参数

MAX9967BGCCQ 数据手册

与MAX9967BGCCQ相关器件

与MAX9967BGCCQ相关文章

您还可以找

您在本页遇到什么问题？