EVALUATION KIT AVAILABLE
Click here for production status of specific part numbers.
MAX41463/MAX41464
300MHz–960MHz (G)FSK
Transmitter with I C Interface
2
General Description
Benefits and Features
● Low Implementation Cost
The MAX41463/MAX41464 is a UHF sub-GHz ISM/SRD
transmitter designed to transmit Frequency-Shift Keying
(FSK), or Gaussian (G)FSK (or 2GFSK) data in the 286MHz
to 960MHz frequency range. It integrates a fractional phase-
locked-loop (PLL) so that a single, low-cost crystal can be
used to generate commonly used world-wide sub-GHz
frequencies. The fast response time of the PLL allows for
frequency-hoppingspreadspectrumprotocolsforincreased
range and security. The chip also features preset modes
with pin-selectable frequencies so that only one wire is
required for an external microcontroller interface. The only
frequency-dependent components required are for the
external antenna-matching network. A buffered clock-out
signal at 800kHz is also provided. Optionally, the device
can be put into programmable mode and programmed
• Bits-to-RF Single Wire Operation
• Low Bill-of-Materials (BOM)
• Uses Single, Low-Cost, 16MHz Crystal
• Small 3mm x 3mm TSSOP10 Package
● Increased Range, Data Rates, and Security
• Up to +16dBm PA Output Power
• Fast Frequency Switching for FHSS/DSSS
• Fast-On Oscillator: <250μs Startup Time
• Up to 200kbps NRZ Data Rate
● Extend Battery Life with Low Supply Current
• < 12mA Typical Current Consumption at 315MHz
• Selectable Standby and Shutdown Modes
• Auto Shutdown at < 20nA (typ) Current
● Ease-of-Use
2
• Pin-Selectable Frequencies
using an I C interface. The crystal-based architecture
• Pin-Compatible ASK and FSK Versions
• +1.8V to +3.6V Single-Supply Operation
• Fully Programmable with 400kHz/1MHz I C
of the MAX41463/MAX41464 eliminates many of the
common problems with SAW-based transmitters by
providing greater modulation depth, faster frequency
settling, higher tolerance of the transmit frequency, and
reduced temperature dependence.
2
Interface
Ordering Information appears at end of data sheet.
The MAX41463/MAX41464 provides output power up
to +13dBm into a 50Ω load while drawing < 12mA at
315MHz. The output load can be adjusted to increase
power up to +16dBm, and a PA boost mode can be
enabled at frequencies above 850MHz to compensate for
losses. The PA output power can also be controlled using
2
programmable register settings in I C mode.
Simplified Block Diagram
The MAX41463/MAX41464 also features single-supply
operation from +1.8V to +3.6V. The device has an auto-
shutdown feature to extend battery life and a fast oscillator
wake-up with data activity detection.
DATA
/SDA
PA CONTROL
VDD
GND
The MAX41463/MAX41464 is available in a 10-pin
TSSOP package and is specified over the -40°C to
+105°C extended temperature range.
DATA ACTIVITY
DETECTOR
PA
PAOUT
PAGND
SEL[1:0]
Applications
LOCK DETECT
FRAC-N
PLL
● Building Automation and Security
● Wireless Sensors and Alarms
● Remote and Passive Keyless Entry (RKE/PKE)
● Tire Pressure Monitoring Systems (TPMS)
● Automatic Meter Reading (AMR)
● Garage Door Openers (GDO)
● Radio Control Toys
XTAL1
XTAL2
CLKOUT
/SCL
CRYSTAL OSCILLATOR
/16
● Internet of Things (IoT)
19-100324; Rev 1; 11/18