5秒后页面跳转
MAX3227EIDBRG4 PDF预览

MAX3227EIDBRG4

更新时间: 2024-11-23 14:53:03
品牌 Logo 应用领域
德州仪器 - TI 驱动光电二极管接口集成电路驱动器
页数 文件大小 规格书
22页 641K
描述
3-V to 5.5-V Single-Channel RS-232 Line Driver/Receiver 16-SSOP -40 to 85

MAX3227EIDBRG4 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Obsolete零件包装代码:SOIC
包装说明:SSOP, SSOP16,.3针数:16
Reach Compliance Code:unknownECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.02
差分输出:NO驱动器位数:1
高电平输入电流最大值:0.000001 A输入特性:SCHMITT TRIGGER
接口集成电路类型:LINE TRANSCEIVER接口标准:EIA-232-F; TIA-232-F; V.28
JESD-30 代码:R-PDSO-G16JESD-609代码:e4
长度:6.2 mm湿度敏感等级:1
功能数量:1端子数量:16
最高工作温度:70 °C最低工作温度:
最小输出摆幅:10 V最大输出低电流:0.0016 A
封装主体材料:PLASTIC/EPOXY封装代码:SSOP
封装等效代码:SSOP16,.3封装形状:RECTANGULAR
封装形式:SMALL OUTLINE, SHRINK PITCH峰值回流温度(摄氏度):260
电源:3.3/5 V认证状态:Not Qualified
最大接收延迟:接收器位数:1
座面最大高度:2 mm子类别:Line Driver or Receivers
最大压摆率:0.01 mA最大供电电压:5.5 V
最小供电电压:3 V标称供电电压:3.3 V
表面贴装:YES温度等级:COMMERCIAL
端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)端子形式:GULL WING
端子节距:0.65 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:5.3 mm
Base Number Matches:1

MAX3227EIDBRG4 数据手册

 浏览型号MAX3227EIDBRG4的Datasheet PDF文件第2页浏览型号MAX3227EIDBRG4的Datasheet PDF文件第3页浏览型号MAX3227EIDBRG4的Datasheet PDF文件第4页浏览型号MAX3227EIDBRG4的Datasheet PDF文件第5页浏览型号MAX3227EIDBRG4的Datasheet PDF文件第6页浏览型号MAX3227EIDBRG4的Datasheet PDF文件第7页 
MAX3223E  
www.ti.com.......................................................................................................................................... SLLS707A JANUARY 2006REVISED SEPTEMBER 2009  
3-V TO 5.5-V MULTICHANNEL RS-232 LINE DRIVER/RECEIVER  
WITH ±15-kV ESD PROTECTION  
Check for Samples: MAX3223E  
1
FEATURES  
DB, DW, OR PW PACKAGE  
ESD Protection for RS-232 Bus Pins  
(TOP VIEW)  
±15-kV Human-Body Model (HBM)  
EN  
C1+  
1
20 FORCEOFF  
±8-kV IEC61000-4-2, Contact Discharge  
±15-kV IEC61000-4-2, Air-Gap Discharge  
2
19  
18  
17  
16  
15  
14  
13  
12  
11  
V
CC  
3
V+  
GND  
Meets or Exceeds the Requirements of  
TIA/EIA-232-F and ITU v.28 Standards  
4
C1−  
DOUT1  
RIN1  
5
C2+  
Operates With 3-V to 5.5-V VCC Supply  
Operates up to 500 kbit/s  
6
C2−  
ROUT1  
FORCEON  
DIN1  
7
V−  
8
DOUT2  
RIN2  
ROUT2  
Two Drivers and Two Receivers  
Low Standby Current . . . 1 μA Typ  
External Capacitors . . . 4 × 0.1 μF  
Accepts 5-V Logic Input With 3.3-V Supply  
9
DIN2  
10  
INVALID  
Alternative High-Speed Pin-Compatible Device  
(1 Mbit/s) for SNx5C3223E  
APPLICATIONS  
Battery-Powered Systems  
PDAs  
Notebooks  
Laptops  
Palmtop PCs  
Hand-Held Equipment  
DESCRIPTION/ORDERING INFORMATION  
The MAX3223E consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD  
protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of  
TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the  
serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to  
5.5-V supply. The device operates at typical data signaling rates up to 500 kbit/s and a maximum of 30-V/μs  
driver output slew rate.  
Flexible control options for power management are available when the serial port is inactive. The  
auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of  
operation, if the device does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is  
set low and EN is high, both drivers and receivers are shut off, and the supply current is reduced to 1 mA.  
Disconnecting the serial port or turning off the peripheral drivers causes auto-powerdown to occur.  
Auto-powerdown can be disabled when FORCEON and FORCEOFF are high. With auto-powerdown enabled,  
the device is activated automatically when a valid signal is applied to any receiver input. The INVALID output is  
used to notify the user if an RS-232 signal is present at any receiver input. INVALID is high (valid data) if any  
receiver input voltage is greater than 2.7 V or less than –2.7 V, or has been between –0.3 V and 0.3 V for less  
than 30 μs. INVALID is low (invalid data) if the receiver input voltage is between –0.3 V and 0.3 V for more than  
30 μs. Refer to Figure 4 for receiver input levels.  
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas  
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
PRODUCTION DATA information is current as of publication date.  
Copyright © 2006–2009, Texas Instruments Incorporated  
Products conform to specifications per the terms of the Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  

MAX3227EIDBRG4 替代型号

型号 品牌 替代类型 描述 数据表
TRS3227IDBR TI

完全替代

具有 +/-15kV ESD 保护的 3V 至 5.5V 单通道 1Mbps RS-232
MAX3227EIDBR TI

完全替代

3-V TO 5.5-V SINGLE-CHANNEL RS-232 LINE DRIVE
MAX3227EIDB TI

完全替代

3-V TO 5.5-V SINGLE-CHANNEL RS-232 LINE DRIVE

与MAX3227EIDBRG4相关器件

型号 品牌 获取价格 描述 数据表
MAX3227I TI

获取价格

3-V TO 5.5-V TWO-CHANNEL RS-232 1-MBIT/S LINE
MAX3227IDB TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 LINE DRIVE
MAX3227IDBE4 TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 LINE DRIVE
MAX3227IDBR TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 LINE DRIVE
MAX3227IDBRE4 TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 LINE DRIVE
MAX3228 MAXIM

获取价格

+2.5V to +5.5V RS-232 Transceivers in UCSP
MAX3228AE MAXIM

获取价格

±15kV ESD-Protected +2.5V to +5.5V RS-232 Tra
MAX3228AE ADI

获取价格

±15kV ESD保护、+2.5V至+5.5V、RS-232收发器,UCSP和WLP封装
MAX3228AEEWV+T MAXIM

获取价格

±15kV ESD-Protected +2.5V to +5.5V RS-232 Tra
MAX3228E MAXIM

获取价格

【15kV ESD-Protected @.5V to %.5V RS-232 Trans