Click here to ask about the production status of specific part numbers.
Evaluates: MAX25301A/MAX25301B
MAX25301 Evaluation Kit
General Description
Quick Start
The MAX25301 evaluation kit (EV kit) evaluates the
MAX25301A/MAX25301B IC family of low noise linear
regulators. The EV kit operates over an input range of
1.7V to 5.5V, provides any output voltage range from 0.6V
to 5.3V, and delivers up to 1A of current. The EV kit comes
with the MAX25301BATB/V+ installed.
Required Equipment
●
●
●
●
MAX25301 EV kit
5.5V, 1A DC power supply
Electronic load capable of 1A
Digital voltmeter (DVM)
Features
Procedure
● Evaluates the MAX25301A/MAX25301B IC in a
The EV kit is fully assembled and tested. To verify board
operation, follow the steps:
10-pin (3mm x 3mm) TDFN
● 1.7V to 5.5V Input Range
Caution:Donotturnonpowersupplyuntilallconnections
are completed.
● 0.6V to 5.3V Resistor-Configurable Output Voltage
(MAX25301B, On Board with Output Set to 3.3V)
1) Verify that jumpers JU101, SELA and SELB are in
their default positions, as shown in Tables 1, 2, and 3.
2) Connect the 5.5V power supply between the IN and
nearest GND terminal posts.
3) Connect the 1A electronic load between the OUT
and nearest GND terminal posts.
4) Connect the DVM between the OUT and nearest
GND terminal posts.
5) Turn on the power supply.
● 1.2V to 5.0V Jumper-Configurable Output Voltage
(MAX25301A, with IC Replacement)
● Up to 1A Output Current
● Proven 2-Layer 1oz Copper PCB Layout
● Demonstrates Compact Solution Size
● Fully Assembled and Tested
6) Enable the electronic load.
7) Verify that the voltage at the OUT terminal post is
approximately 3.3V.
Ordering Information appears at end of data sheet.
MAX25301 EV Kit Files
FILE
DECRIPTION
EV Kit Bill of Material
EV Kit Layout
MAX25301 EV Kit BOM
MAX25301 EV Kit PCB Layout
MAX25301 EV Kit Schematic
EV Kit Schematic
319-100571; Rev 0; 8/20