Click here to ask an associate for production status of specific part numbers.
Highly Integrated, 4-Channel Sequencer and
MAX16165/MAX16166
Supervisor
Applications
General Description
•
Latch-Up Prevention and Inrush Current Protection
in Multi-Supply Systems
The MAX16165/MAX16166 monitor up to five voltages
and sequence up to four voltages. These devices
provide an adjustable delay as each supply is turned on
as well as monitor each power-supply voltage, including
•
•
•
•
•
FPGA/ASIC Power Supply Sequencing
Servers and Security Cameras
Test Equipment
Networking Equipment
Industrial Sensors and Motor Controls
the input voltage VDD
.
The MAX16165/MAX16166 operate from a supply range
of 2.7V to 16V and have an internal regulator output
(ABP), power internal circuits, and supply more than
1mA additional current to any external circuitry.
Benefits and Features
• 2.7V to 16.0V Wide Operating Voltage Range
•
•
•
•
•
•
•
Monitor Up to Five Voltages
Sequence Up to Four Voltages
The sequencing is enabled by two inputs, ON and OFF.
A rising edge on the ON input initiates power-on
sequencing of the channels whereas a falling edge on
OFF input initiates power-off sequencing. During the
power-on sequencing, when all of the voltages reach
their final values, a sequencing done output DONE
asserts high followed by a Power-OK (POK) output after
the reset delay timer has expired, allowing the
microcontroller (μC) to operate. If any voltage falls below
its threshold, the reset output asserts and all voltage
supplies are turned off. When the sequencer initiates a
power-off sequencing, the MAX16165/MAX16166 can
reverse sequence the outputs.
Power-Off in Reverse Order or Simultaneously
Unlimited Daisy-Chain
Capacitor-Adjustable Sequencing Delay
Capacitor-Adjustable Power-Good Timeout
Resistor-Configurable Power-Supply On and
Off Thresholds
•
Open-Drain (MAX16165)/Push-Pull (MAX16166)
Outputs
•
•
•
•
POK Output for System Microcontroller Reset
Bidirectional FAULT Input/Output
4 x 5-Bump WLP and 20L TQFN Package
-40°C to +125°C Operating Temperature Range
Output options available are open-drain (MAX16165)
and push-pull (MAX16166). The MAX16165/MAX16166
can be daisy-chained unlimited amount to time to control
any number of voltages in a system.
Ordering Information appears at end of data sheet.
The MAX16165/MAX16166 feature a bidirectional active
low FAULT input/output, which asserts low during any
fault condition. FAULT stays low as long as an
undervoltage event is present at UVSET Input and it is a
one-shot output during all other FAULT conditions. An
external signal pulling FAULT low disables all outputs
immediately. The MAX16165/MAX16166 are available
in a 1.63mm x 2.03mm, 20-bump Wafer-Level Package
(WLP) and a 4mm x 4mm, 20L TQFN package. The
device is fully specified over the -40°C to +125°C
operating temperature range.
19-101178; Rev 0; 11/21
© 2021 Analog Devices, Inc. All rights reserved. Trademarks and registered trademarks are the property of their respective ow ners.
One Analog Way, Wilmington, MA 01887 U.S.A. | Tel: 781.329.4700 | © 2021 Analog Devices, Inc. All rights reserved.