Order this document
by MAC6071/D
SEMICONDUCTOR TECHNICAL DATA
*Motorola preferred devices
Silicon Bidirectional Thyristors
. . . designed primarily for full-wave ac control applications, such as light dimmers,
motor controls, heating controls and power supplies; or wherever full-wave silicon
gate controlled solid-state devices are needed. Triac type thyristors switch from a
blocking to a conducting state for either polarity of applied anode voltage with positive
or negative gate triggering.
TRIACs
4 AMPERES RMS
200 thru 600 VOLTS
•
Sensitive Gate Triggering (A and B versions) Uniquely Compatible for Direct
Coupling to TTL, HTL, CMOS and Operational Amplifier Integrated Circuit Logic
Functions
MT1
•
•
•
Gate Triggering 4 Mode — MAC6071A,B, MAC6073A,B, MAC6075A,B
Blocking Voltages to 600 Volts
All Diffused and Glass Passivated Junctions for Greater Parameter Uniformity
and Stability
MT2
G
•
Small, Rugged, Thermopad Construction for Low Thermal Resistance, High Heat
Dissipation and Durability
MT2
CASE 77-08
(TO-225AA)
STYLE 5
G
MT2
MT1
MAXIMUM RATINGS (T = 25°C unless otherwise noted)
J
Rating
Symbol
Value
Unit
(1)
Peak Repetitive Off-State Voltage
V
DRM
Volts
(Gate Open, T = 25 to 110°C)
MAC6071A,B
MAC6073A,B
MAC6075A,B
200
400
600
J
On-State Current RMS (T = 85°C)
I
4
Amps
Amps
C
T(RMS)
Peak Surge Current (One Full cycle, 60 Hz, T = –40 to +110°C)
I
30
3.7
10
0.5
5
J
TSM
2
I t
2
A s
Circuit Fusing Considerations (t = 8.3 ms)
Peak Gate Power
P
GM
Watts
Watt
Volts
°C
Average Gate Power
P
G(AV)
Peak Gate Voltage
V
GM
Operating Junction Temperature Range
Storage Temperature Range
T
J
–40 to +110
–40 to +150
8
T
stg
°C
(2)
Mounting Torque (6-32 Screw)
—
in. lb.
1. V
for all types can be applied on a continuous basis. Blocking voltages shall not be tested with a constant current source such that the
DRM
voltage ratings of the devices are exceeded.
2. Torque rating applies with use of compression washer (B52200F006). Mounting torque in excess of 6 in. lb. does not appreciably lower
case-to-sink thermal resistance. Main terminal 2 and heatsink contact pad are common.
For soldering purposes (either terminal connection or device mounting), soldering temperatures shall not exceed +200°C, for 10 seconds.
Consult factory for lead bending options.
This document contains information on a new product. Specifications and information herein are subject to change without notice.
Preferred devices are Motorola recommended choices for future use and best overall value.
1
Motorola Thyristor Device Data
Motorola, Inc. 1996