SPECIFICATION FOR SMT OSCILLATOR
MtronPTI P/N M2005S025
I. GENERAL & ELECTRICAL REQUIREMENTS:
1. AVAILABLE FREQUENCY RANGE: 3.686400 MHz to 40.000000 MHz
2. FREQUENCY STABILITY: ± 100 ppm max.
3. OPERATING TEMPERATURE RANGE: -40°C to +85°C
4. OPERATING VOLTAGE (Vdd): 3.3 V ± 0.165 V
5. OPERATING CURRENT: 35 mA max.
6. OUTPUT TYPE: HCMOS/TTL Compatible
7. SYMMETRY: 40/60% ref. to ½ Vdd
8. RISE/FALL TIME: 6 nS max. ref. between 10% and 90%
9. OUTPUT LOGIC LEVELS: VOL = 10% Vdd max. VOH = 90% Vdd min.
10. OUTPUT LOAD: 15 pF max.
11. JITTER (Cycle-to-Cycle): 15 pS RMS max.
12. TRISTATE FUNCTION (Pad 1): Logic “high” or “floating”, clock signal output
Logic “low”, output disables to high impedance state
13. TRISTATE INPUT CURRENT: (Pad 1): 130 µA max.
14. START-UP TIME: 8.5 mS max. under load and over operating temperature.
Figure 1
II. ENVIRONMENTAL & MECHANICAL REQUIREMENTS:
1. SHOCK: MIL-STD-202, Method 213, Condition C.
2. VIBRATION: MIL-STD-202, Methods 201 & 204.
3. EARLY FAILURE RATE: 400 ppm max.
4. LONG TERM RELIABILITY: 75 FIT @ +45°C
5. HERMETICITY: 1 X 10 -8 atm cc/sec min.
6. SOLDERABILITY: Per EIAJ-STD-002
7. REFLOW SOLDER CONDITIONS: See figure 1.
8. PACKAGE: 4- J lead ceramic package with 12- 40 µinches max. of gold plating
over a min. of 50 µinches of nickel plating.
III. DIMENSIONS:
IV. DATA SHEET REVISION TABLE:
Date
Rev.
0
A
B
PCN
N/A
N/A
N/A
Details of Revision
Original release.
Changed lead finish to gold flash instead of solder tinned.
Added Tristate Input Current spec. Added J-lead gold plating information
6/15/04
12/8/04
11/7/05
The information contained herein is proprietary to MtronPTI and is
submitted in confidence. Information may not be copied or divulged without written permission from MtronPTI.