LTC1091/ LTC1092
LTC1093/ LTC1094
1-, 2-, 6- a nd 8-Cha nne l, 10-Bit
Se ria l I/ O Da ta Ac q uisitio n Syste m s
and-holds. On-chip serial ports allow efficient data trans-
fer to a wide range of microprocessors and microcontrol-
lers. These circuits can provide a complete data acquisi-
tionsysteminratiometricapplications orcanbeusedwith
an external reference in others.
FEATURES
■
Programmable Features
– Unipolar/Bipolar Conversions
–
Differential/Single-Ended Multiplexer
Configurations
The high impedance analog inputs and the ability to
operate with reduced spans (below 1V full scale) allow
direct connection to sensors and transducers in many
applications, eliminating the need for gain stages.
■
■
■
Sample-and-Holds
Single Supply 5V, 10V or ±5V Operation
Direct 3- or 4-Wire Interface to Most MPU Serial
Ports and All MPU Parallel I/O Ports
Analog Inputs Common Mode to Supply Rails
Resolution: 10 Bits
Total Unadjusted Error (A Grade): ±1LSB Over Temp
Fast Conversion Time: 20µs
Low Supply Current
■
■
■
■
■
An efficient serial port communicates without external
hardware to most MPU serial ports and all MPU parallel
I/O ports allowing eight channels of data to be transmitted
over as few as three wires. This, coupled with low power
consumption, makes remote location possible and facili-
tates transmitting data through isolation barriers.
LTC1091: 3.5mA Max, 1.5mA Typ
LTC1092/LTC1093/LTC1094: 2.5mA Max, 1mA Typ
Temperature drift of offset, linearity and full-scale error
are all extremely low (1ppm/°C typically) allowing all
grades to be specified with offset and linearity errors of
±0.5LSB maximum over temperature. In addition, the A
grade devices are specified with full-scale error and total
unadjusted error (including the effects of offset, linearity
and full-scale errors) of ±1LSB maximum over tempera-
ture. The lower grade has a full-scale specification of
±2LSB for applications where full scale is adjustable or
less critical.
U
DESCRIPTIO
The LTC®1091/LTC1092/LTC1093/LTC1094 10-bit data
acquisition systems are designed to provide complete
function, excellent accuracy and ease of use when digitiz-
ing analog data from a wide variety of signal sources and
transducers. Built around a 10-bit, switched capacitor,
successiveapproximationA/Dcore, thesedevices include
softwareconfigurableanalogmultiplexers andbipolarand
unipolar conversion modes as well as on-chip sample-
, LTC and LT are registered trademarks of Linear Technology Corporation.
U
TYPICAL APPLICATION
1.25
V
CC
= 5V
1.00
0.75
0.50
0.25
0
4.7µF
5V
MPU
(e.g., 8051)
1
2
3
4
8
7
6
5
V
(V
REF
CC
)
CS
P1.4
P1.3
P1.2
ANALOG INPUT #1
0V TO 5V RANGE
ANALOG INPUT #2
0V TO 5V RANGE
CLK
CH0
CH1
GND
LTC1091
D
OUT
1091 TA01
SERIAL DATA LINK
D
IN
FOR 8051 CODE SEE
APPLICATIONS INFORMATION
SECTION
0
1
2
3
4
5
REFERENCE VOLTAGE (V)
1091 TA02
1