LT1352/LT1353
Dual and Quad
250µA, 3MHz, 200V/µs
Operational Amplifiers
U
DESCRIPTIO
FEATURES
The LT®1352/LT1353 are dual and quad, very low power,
high speed operational amplifiers with outstanding AC
and DC performance. The amplifiers feature much lower
supply current and higher slew rate than devices with
comparable bandwidth. The circuit combines the slewing
performance of a current feedback amplifier in a true
operational amplifier with matched high impedance
inputs. The high slew rate ensures that the large-signal
bandwidth is not degraded. Each output is capable of
drivinga1kΩloadto±13Vwith±15Vsuppliesanda500Ω
load to ±3.4V on ±5V supplies.
■
3MHz Gain Bandwidth
■
200V/µs Slew Rate
■
250µA Supply Current per Amplifier
C-LoadTM Op Amp Drives All Capacitive Loads
■
■
Unity-Gain Stable
■
Maximum Input Offset Voltage: 600µV
■
Maximum Input Bias Current: 50nA
■
Maximum Input Offset Current: 15nA
■
Minimum DC Gain, RL = 2k: 30V/mV
■
Input Noise Voltage: 14nV/√Hz
■
Settling Time to 0.1%, 10V Step: 700ns
■
Settling Time to 0.01%, 10V Step: 1.25µs
The LT1352/LT1353 are members of a family of fast, high
performance amplifiers using this unique topology and
employing Linear Technology Corporation’s advanced
complementary bipolar processing. For higher bandwidth
deviceswithhighersupplycurrentseetheLT1354through
LT1365datasheets.Bandwidthsof12MHz,25MHz,50MHz
and 70MHz are available with 1mA, 2mA, 4mA and 6mA of
supply current per amplifier. Singles, duals and quads of
each amplifier are available. The LT1352 is available in an
8-lead SO package. The LT1353 is offered in a 14-lead
narrow surface mount package.
■
Minimum Output Swing into 1k: ±13V
■
Minimum Output Swing into 500Ω: ±3.4V
■
Specified at ±2.5V, ±5V and ±15V
Available in SO-8 Package
■
■
LT1353 in Narrow Surface Mount Package
U
APPLICATIO S
■
Battery-Powered Systems
■
Wideband Amplifiers
■
Buffers
Active Filters
Data Acquisition Systems
Photodiode Amplifiers
, LTC and LT are registered trademarks of Linear Technology Corporation.
C-Load is a trademark of Linear Technology Corporation.
■
■
■
U
TYPICAL APPLICATIO
Instrumentation Amplifier
Large-Signal Response
R1
50k
R2
5k
R5
1.1k
R4
50k
R3
5k
–
1/2
LT1352
–
1/2
LT1352
+
V
+
–
IN
OUT
V
+
GAIN = [R4/R3][1 + (1/2)(R2/R1 + R3/R4) + (R2 + R3)/R5] = 102
TRIM R5 FOR GAIN
TRIM R1 FOR COMMON MODE REJECTION
BW = 30kHz
AV = –1
1352/53 TA02
1352/53 TA01
13523fa
1