May 1998
LM614
Quad Operational Amplifier and Adjustable Reference
General Description
The LM614 consists of four op-amps and a programmable
Features
Op Amp
voltage reference in
a 16-pin package. The op-amp
n Low operating current: 300 µA
n Wide supply voltage range: 4V to 36V
n Wide common-mode range: V− to (V+− 1.8V)
out-performs most single-supply op-amps by providing
higher speed and bandwidth along with low supply current.
This device was specifically designed to lower cost and
board space requirements in transducer, test, measurement
and data acquisition systems.
±
n Wide differential input voltage:
36V
n Available in plastic package rated for Military
Temperature Range Operation
Combining a stable voltage reference with four wide output
swing op-amps makes the LM614 ideal for single supply
transducers, signal conditioning and bridge driving where
large common-mode-signals are common. The voltage ref-
erence consists of a reliable band-gap design that maintains
low dynamic output impedance (1Ω typical), excellent initial
tolerance (0.6%), and the ability to be programmed from
1.2V to 6.3V via two external resistors. The voltage refer-
ence is very stable even when driving large capacitive loads,
as are commonly encountered in CMOS data acquisition
systems.
Reference
n Adjustable output voltage: 1.2V to 6.3V
n Tight initial tolerance available:
n Wide operating current range: 17 µA to 20 mA
n Tolerant of load capacitance
±
0.6%
Applications
n Transducer bridge driver and signal processing
n Process and mass flow control systems
n Power supply voltage monitor
™
As a member of National’s new Super-Block family, the
n Buffered voltage references for A/D’s
LM614 is a space-saving monolithic alternative to a multichip
solution, offering a high level of integration without sacrificing
performance.
Connection Diagram
DS009326-1
Ordering Information
Reference
Temperature Range
Package
NSC
Tolerance & VOS
Drawing
Military
−55˚C ≤ TA ≤ +125˚C
LM614AMN
Industrial
−40˚C ≤ TA ≤ +85˚C
LM614AIN
Commercial
0˚C ≤ TA ≤ +70˚C
—
±
@
0.6%
16-pin
Molded DIP
16-pin
N16E
J16A
N16E
M16B
80 ppm/˚C max
VOS ≤ 3.5 mV max
LM614AMJ/883
(Note 13)
—
—
Ceramic DIP
16-pin
±
@
2.0%
LM614MN
LM614BIN
LM614WM
LM614CN
LM614CWM
150 ppm/˚C max
Molded DIP
16-pin Wide
Surface Mount
VOS ≤ 5.0 mV
—
™
Super-Block is a trademark of National Semiconductor Corporation.
© 1999 National Semiconductor Corporation
DS009326
www.national.com