LM2755
www.ti.com
SNVS433D –OCTOBER 2007–REVISED APRIL 2013
LM2755 Charge Pump LED Controller with I2C-Compatible Interface in DSBGA Package
Check for Samples: LM2755
1
FEATURES
DESCRIPTION
The LM2755 is a charge-pump-based, constant
current LED driver capable of driving 3 LEDs with a
total output current up to 90mA. The diode current
waveforms of each LED can be trapezoidal with
timing and level parameters (rise time, fall time, high
level, low level, delay, high time, low time)
programmed via an I2C-compatible interface. The 32
brightness levels found on the LM2755 are
exponentially spaced (as opposed to linearly spaced)
to better match the response of the human eye to
changing brightness levels.
2
•
90% Peak Efficiency
•
•
Total solution size < 13mm2
No Inductor Required: Only 4 Inexpensive
Ceramic Caps
•
•
•
3 Independently Controlled Constant Current
Outputs
Programmable Trapezoidal Dimming
Waveform on Each Output
Programmable Timing Control Via Internal
Registers and External Clock Synchronization
Input
The device requires only four small and low-cost
ceramic capacitors. The LM2755 provides excellent
efficiency without the use of an inductor by operating
the charge pump in a gain of 3/2 or in a gain of 1.
Maximum efficiency is achieved over the input
voltage range by actively selecting the proper gain
based on the LED forward voltage requirements.
•
•
32 Exponential Dimming Steps with 800:1
Dimming Ratio
Programmable Brightness Control via I2C-
Compatible Interface
•
•
•
Hardware Enable Pin
The pre-regulation scheme used by the LM2755 is
optimized to ensure low conducted noise on the
input. An internal soft-start circuitry eliminates high
inrush current at start-up. The LM2755 consumes
3µA (typ.) of supply current in shut-down.
Wide Input Voltage Range: 2.7V to 5.5V
Tiny 18-bump Thin DSBGA : 1.8mm x 1.6mm x
0.6mm
APPLICATIONS
The LM2755 is available in Texas Instruments' tiny
18-bump thin DSBGA package.
•
•
•
•
Indicator LEDs
Keypad LED Backlight
Display LED Backlight
Fun-light LEDs
TYPICAL APPLICATION CIRCUIT
0.47 mF
0.47 mF
3.1 mm
C2
C
OUT
C1- C1+ C2- C2+
V
P
OUT
IN
C1
1 mF
1 mF
C
IN
ADR
VIO
SCL
SDIO
SYNC
LM2755
SCL
R
SET
SDIO
D1
D2
D3
HWEN
VIO
Dx Pins
SYNC
HWEN
I
SET
GND ADDR
Capacitors:
TDK C1005X5R1A105M and C1005X5R1A474M ,
or 1 mF and 0.47 mF single capacitor equivalent
12.5 kW
Figure 1. Typical Application Circuit
Figure 2. Minimum Solution Size
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
All trademarks are the property of their respective owners.
2
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2007–2013, Texas Instruments Incorporated