Sample &
Buy
Support &
Community
Product
Folder
Tools &
Software
Technical
Documents
LM20143, LM20143-Q1
SNVS528H –OCTOBER 2007–REVISED JANUARY 2016
LM20143/LM20143-Q1 3-A PowerWise™ Adjustable Frequency Synchronous Buck
Regulator
1 Features
3 Description
The LM20143 devices are full featured PowerWise™
adjustable frequency synchronous buck regulators
capable of delivering up to 3 A of continuous output
current. The current mode control loop can be
compensated to be stable with virtually any type of
output capacitor. For most cases, compensating the
device only requires two external components,
providing maximum flexibility and ease of use. The
device is optimized to work over the input voltage
range of 2.95 V to 5.5 V, making it suited for a wide
variety of low voltage systems.
1
•
Available in AEC-Q100 Temperature Grade 1
Input Voltage Range: 2.95 V to 5.50 V
Accurate Current Limit Minimizes Inductor Size
97% Peak Efficiency
•
•
•
•
•
Adjustable Output Voltage Down to 0.80 V
Adjustable Switching Frequency (500 kHz to 1.5
MHz)
•
•
•
•
•
•
•
32-mΩ Integrated FET Switches
Starts into Prebiased Loads
The device features internal over voltage protection
(OVP) and over current protection (OCP) circuits for
increased system reliability. A precision enable pin
and integrated UVLO allows the turn-on of the device
to be tightly controlled and sequenced. Start-up
inrush currents are limited by both an internally fixed
and externally adjustable Soft-Start circuit. Fault
detection and supply sequencing is possible with the
integrated power good circuit.
Output Voltage Tracking
Peak Current Mode Control
Adjustable Soft-Start with External Capacitor
Precision Enable Pin with Hysteresis
Integrated OVP, UVLO, Power Good and Thermal
Shutdown
2 Applications
The frequency of this device can be adjusted from
500 kHz to 1.5 MHz by connecting an external
resistor from the RT pin to ground.
•
•
•
Simple to Design, High Efficiency Point of Load
Regulation from a 5-V or 3.3-V Bus
High Performance DSPs, FPGAs, ASICs, and
Microprocessors
The LM20143 is designed to work well in multi-rail
power supply architectures. The output voltage of the
device can be configured to track a higher voltage rail
using the SS/TRK pin. If the output of the LM20143 is
pre-biased at startup it will not sink current to pull the
output low until the internal soft-start ramp exceeds
the voltage at the feedback pin.
Broadband, Networking, and Optical
Communications Infrastructure
Device Information(1)
PART NUMBER
LM20143
PACKAGE
BODY SIZE (NOM)
HTSSOP (16)
4.40 mm × 5.00 mm
LM20143-Q1
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
Typical Application Circuit
L
LM20143
V
OUT
SW
FB
V
IN
PVIN
EN
R
R
FB1
C
IN
R
C
F
C
OUT
AVIN
RT
FB2
PGOOD
F
R
T
VCC
COMP
C
VCC
SS/TRK
PGND AGND
R
C1
C
SS
C
C1
(optional)
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.