LH1540
HIGH VOLTAGE, SOLID STATE RELAY
OPTOCOUPLER
FEATURES
Package Dimensions in Inches (mm)
• Normally Open, Single Pole Single Throw Operation
• Control 350 VAC or DC Voltage
• Switch 150 mA Loads
• LED Control Current, 1 mA,Typical
• Low ON-Resistance, 20 Ω Typ. at 50 mA
Pin One ID.
2
1
3
1
2
6
5
A
K
S
.248 (6.30)
.256 (6.50)
NC
• Isolation Test Voltage, 3750 VAC
• Current Limit Protection
• Underwriters Lab File # E52744
RMS
4
5
6
3
4
NC
S'
.335 (8.50)
.343 (8.70)
.300 (7.62)
Typ.
APPLICATIONS
.039
(1.00)
Min.
• Telephone Switch Hook
• High Voltage Test Equipment
• TRIAC Driver
• Motor Control
• Industrial Control Systems
.130 (3.30)
.150 (3.81)
4°
Typ.
18° Typ.
.110 (2.79
.150 (3.81
.020 (.051) Min.
.010 (.25)
.014 (.35)
.031 (0.80)
.035 (0.90)
.018 (0.45)
.022 (0.55)
.300 (7.62)
.347 (8.82)
DESCRIPTION
.100 (2.54) Typ.
The LH1540 is a single pole single throw (SPST), normally open
(NO), solid state relay. The relay can control AC or DC loads
currents up to 100 mA, with a supply voltage up to 350 V. The
device is packaged in a six pin 0.3 inch dual-in line package.
This package offers an insulation dielectric withstand of 3750
Absolute Maximum Ratings (T =25°C)
Emitter
A
Reverse Voltage................................................................... 6.0 V
Continuous Forward Current .............................................60 mA
Peak Forward Current (1 µs) ..................................................1 A
Power Dissipation ........................................................... 100 mW
Derate Linearly from 25°C .......................................... 1.3 mW/°C
Detector
Output Breakdown Voltage................................................. 350 V
Continous Load Current ..................................................150 mA
Total Power Dissipation................................................... 400 mW
Derate Linearly from 25°C .......................................See Figure 3
Package
VAC
.
RMS
The coupler consists of a AlGaAs LED that is optically coupled
to a dielectrically isolated photodiode array which drives two
series connected high voltage MOS transistors. The typical
ON-resistance is 20 Ω at 25 mA and is linear up to 50 mA.
There is built-in current limiting circuitry in the detector chip,
enabling it to pass FCC 68-302 and other regulatory voltage
surge requirements when over voltage protection is provided.
Isolation Test Voltage .............................................3750 VAC
Isolation Resistance
RMS
12
11
V =500 V, T =25°C.................................................... ≥10
Ω
Ω
IO
A
V =500 V, T =100°C.................................................. ≥10
IO
A
Power Dissipation ........................................................... 500 mW
Derate Linearly from 25°C .......................................... 2.5 mW/°C
Storage Temperature Range ................................ –40 to +150°C
Operating Temperature Range ............................... –40 to +85°C
Junction Temperature ........................................................ 100°C
Soldering Temperature, 2 mm from case, 10 sec. ............ 260°C
5–205