Le79R241
Intelligent Subscriber Line Interface Circuit
Ve790 Series
Data Sheet
Document ID#: 080249
Version 3
May 2011
Features
•
Monitor of two-wire interface voltages and
currents supports
Ordering Information
Device
Package1,2
Packing3
•
•
Voice transmission
Le79R241JC
Le79R241DJC
Le79R241QC
32 Pin PLCC
32 Pin PLCC (Green) Tubes
32 Pin QFN Trays
Tubes
Programmable DC feed characteristics
-
-
Independent of battery
Current limited
1. Due to size constraints, QFN devices are marked by omitting the
“Le” prefix. For example, Le79R241QC is marked 79R241QC.
2. The green package meets RoHS Directive 2002/95/EC of the Eu-
ropean Council to minimize the environmental impact of electrical
equipment.
•
•
Selectable off-hook and ground-key
thresholds
3. For delivery using a tape and reel packing system, add a "T" suffix
to the OPN (Ordering Part Number) when placing an order.
Subscriber line diagnostics
-
-
-
-
-
Leakage resistance
Loop resistance
Applications
Line capacitance
Bell capacitance
•
Enables a cost effective voice solution for long or
short loop applications providing POTS and
integrated test capabilities
Foreign voltage sensing
•
•
•
•
CO
•
Power cross and fault detection
DLC
•
•
•
Supports internal short loop or external ringing
+5 V and battery supplies
PBX/KTS
Pair Gain
Dual battery operation for system power saving
•
•
Automatic battery switching
Description
Intelligent thermal management
The Le79R241 Intelligent Subscriber Line Interface
Circuit (ISLIC™) device, in combination with a VE790
series ISLAC™ device, implements the telephone line
interface function. This enables the design of a low
cost, high performance, fully software programmable
line interface for multiple country applications
worldwide. All AC, DC, and signaling parameters are
fully programmable via microprocessor or GCI
interfaces on the VE790 series ISLAC device.
Additionally, the Le79R241 ISLIC device has
integrated self-test and line-test capabilities to resolve
faults to the line or line circuit. The integrated test
capability is crucial for remote applications where
dedicated test hardware is not cost effective.
•
•
Compatible with inexpensive protection networks
•
Accommodates low tolerance fuse resistors or
PTC thermistors
Metering capable
•
•
12 kHz and 16 kHz
Smooth polarity reversal
•
•
•
Tip-open state supports ground start signaling
Integrated test load switches/relay drivers
5 REN with DC offset trapezoid.
•
•
•
•
•
For US standard:
drives ring up to 4.4 kft of 26 gauge wire.
drives ring up to 7 kft of 24 gauge wire.
For European (British) standard:
drives ring up to 1.7 km of 0.5 mm copper cable.
•
Space Saving Package Options (8 x 8 QFN)
1
Zarlink Semiconductor Inc.
Zarlink, ZL and the Zarlink Semiconductor logo are trademarks of Zarlink Semiconductor Inc.
Copyright 2007-2011, Zarlink Semiconductor Inc. All Rights Reserved.