LCL1904-L / LCL2304-L
LCL3504-L
MCM LNA
Product Features
Applications
• Multichip Hybrid Module
• GaAs p-HEMT & HBT chip on board
• No matching circuit needed
• High Gain & Low Noise
• Single Supply Voltage (+5V)
• Surface Mount Hybrid Type
• Tape & Reel Packaging
• 2G & 3G Repeater
• Base Station
• PCS, CDMA, W-CDMA
• GSM, DCS, UMTS
• WiMAX, Wibro, WLAN
• RF Sub-Systems
• Small Size, High Heatsink
• Alumina Substrate
Package : CP-16B
• Pb Free / RoHS Standard
Descriptions
RFHIC’s LOW Noise Amplifier series are all hybrid LNA type products which includes all matching for the convenience of
customers. LCL series are focused on higher OIP3 while maintaining low noise. The structure of the device is built with GaAs p-
HEMT die attached on a ceramic thick film substrate. The device is still smaller than the area one would use for the application
notes all together. Depending on the part number, one can use this in different frequency applications. All LNA hybrids are
possible to have custom frequency & spec without any additional NRE cost involved.
All RFHIC products are RoHS compliant.
Electrical Specifications
Parameter
Frequency Range
Units
MHz
dB
LCL1904-L
LCL2304-L LCL3504-L
1750~1870
1920~2170
33.5
2200~2400
31
3400~3600
25.7
Small Signal Gain (S21)
Gain Flatness
34.5
±1
dB
±1.5
-15
±0.8
-15
±0.5
-15
Input Return Loss (S11)
Output Return Loss (S22)
1dB Compression Point (P1dB)
dB
-15
dB
-10
-15
-10
-10
dBm
dBm
dB
18
19
20
19
Output 3rd Order Intercept Point
(OIP3) (TYP.)
33
34
31
34
Noise Figure (TYP.)
1.0
1.0
1.1
1.6
DC Supply Current (Vdc=+5V)
mA
110~150
110~150
110~150
110~150
Test Condition
① Supply voltage = +5V, 50ohm System, Ta = 25℃
② OIP3 is measured with two tones, at an output power of +5dBm/tone separated by 1MHz.
▪ Tel : 82-31-250-5011
▪ rfsales@rfhic.com
page 1/3
▪ All specifications may change without notice.
▪ Version 6.1