L9925
DMOS DUAL FULL BRIDGE DRIVER
2 INDEPENDENTLY CONTROLLED
H-BRIDGES
DS,ON
R
amb
<0.9Ω @ T
S
= 25°C, V = 14V
0.8A DC CURRENT WITHOUT HEAT SINK
LOW QUIESCENT MODE Iq <200µA
THEMAL PROTECTION
CROSSCONDUCTION PROTECTION
SUPPLYVOLTAGEUP TO 40V
CMOS COMPATIBLE INPUTS
OUTPUT SHORT-CIRCUIT PROTECTION
SO28
ORDERING NUMBER: L9925
DESCRIPTION
The L9925 is a dual full bridge driver for stepper
motor applications. Realized in BCD (Bipolar,
CMOS & DOS) techology, logic circuits, precise
linear blocks and power transistors are combined
to optimize circuit performance and minimize off
chip components.Schmitt triggers are used for all
input stages and are fully compatible with 5V
CMOS logic levels. When both enable signals are
low, the IC is commanded to a low quiescent cur-
rent state and will draw less than 200µA from the
battery.
The charge pump is integrated on chip; no exter-
nal componentsare required. Full performance is
maintaned for 9V <VS <16V. Extended ranges of
6V <<VS <9V and 16V <VS <40V yields full func-
tionally but with relaxed performance. Over tem-
perature protection and ESD protection to all pins
ensures relability and reduces system integration
failures.
BLOCK DIAGRAM
OUT1
VS1
OUT2
CHARGE
PUMP
CHARGE
PUMP
IN1
IN2
7V
TEMP
7V
EN1
EN1
7V
T1
T2
EN1
PGND1
1st FULL BRIDGE
T1 T2
EN1
5V
GND
VS2
REGULATOR
40V
T1 T2
EN2
EN2
IN3
IN4
OUT3
OUT4
2nd FULL BRIDGE
D99AT423
March 1999
1/9
...........................................................................................................................................................................................................