Data Sheet
November 2001
L9219A/G Low-Cost Line Interface
with Reverse Battery and Dual Current Limit
Features
Description
■ Basic forward/reverse battery SLIC functionality at
a low cost
This general-purpose electronic subscriber loop
interface circuit (SLIC) is optimized for low cost, while
still providing a satisfactory set of features. This part
is a pin-for-pin replacement for the Agere L9217 and
L9218 SLICs.
■ Pin compatible with Agere Systems Inc. L9217 and
L9218 SLICs
■ Low active power (typical 138 mW during on-hook
transmission)
The L9219 requires a 5 V power supply and single
battery to operate. This device offers forward and
reverse battery operation. The rate of battery rever-
sal may be ramped to meet international require-
ments. Additionally, a low-power scan mode, wherein
all circuitry except the off-hook supervision is shut
down to conserve power, is available.
■ Low-power scan mode for low-power, on-hook
power dissipation (52 mW typical)
■ Distortion-free, on-hook transmission
■ Convenient operating states:
— Forward active-low current limit
— Forward active-high current limit
— Reverse active-low current limit
— Reverse active-high current limit
— Low-power scan
The dc current limit may be programmed via a single
external resistor. Via the logic table, the current limit
may be increased a nominal 42% above the value
PROG
set by the I
resistor, giving the user a high-low
current limit option.
— Disconnect (high impedance)
Device overhead is fixed and is adequate for
3.14 dBm into 900 Ω of on-hook transmission.
■ Minimal external components required
Both the loop supervision and ring trip supervision
functions are offered with user-controlled thresholds
via external resistors.
■ Two gain options to optimize the codec interface
■ Adjustable supervision functions:
— Off-hook detector with hysteresis
— Ring trip detector
The L9219 is offered with a receive gain that is opti-
mized for interface to a first-generation type codec
(L9219A). It is also offered with a gain option that is
optimized for interface to a third- or fourth-generation
type codec (L9219G). In both cases, minimizing
external components required at this interface.
■ Logic controlled high and low current limit
■ Ramped rate of battery reversal
■ Thermal protection with thermal shutdown indica-
tion
Data control is via a parallel data control scheme.
The device is available in a 28-pin PLCC package. It
is built by using a 90 V complementary bipolar
(CBIC) process.