Series JS02 & JS04
Ultra-Miniature SMT DIP Slides
General Specifications
Electrical Capacity (Resistive Load)
Switching Rating:
Nonswitching Rating:
25mA @ 24V DC
0.1A @ 50V DC
Other Ratings
JS02 Extended Actuator
JS04 Flush Actuator
Contact Resistance:
Insulation Resistance:
Dielectric Strength:
Mechanical Life:
Electrical Life:
50 milliohms maximum
50 milliohms maximum
100 megohms minimum @ 500V DC
500V AC minimum for 1 minute minimum
2,000 operations minimum
2,000 operations minimum
.031” (0.8mm)
100 megohms minimum @ 100V DC
300V AC minimum for 1 minute minimum
2,000 operations minimum
2,000 operations minimum
.026” (0.65mm)
Total Travel:
Materials & Finishes
JS02 Extended Actuator
JS04 Flush Actuator
Actuator:
Cover:
Base:
Contacts:
Terminals:
Glass fiber reinforced polyamide
Glass fiber reinforced polyamide (UL94V-0)
Glass fiber reinforced polyamide (UL94V-0)
Beryllium copper with gold plating
Brass with gold plating
Glass fiber reinforced polyamide
Glass fiber reinforced polyamide (UL94V-0)
Glass fiber reinforced polyamide (UL94V-0)
Copper alloy with gold plating
Brass with gold plating
H
Environmental Data
Operating Temp Range:
JS02 Extended Actuator: –25°C through +70°C (–13°F through +158°F)
JS04 Flush Actuator: –30°C through +85°C (–22°F through +185°F)
Humidity:
Vibration:
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning
in 1 minute; 3 right angled directions for 2 hours
Shock:
50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
PCB Processing
Soldering:
Reflow Soldering Recommended. See Profile A in Supplement section.
Manual Soldering: See Profile A in Supplement section.
Note: Switches are packaged in OFF position and should be soldered in OFF position.
These devices are not process sealed. Hand clean locally using alcohol based solution.
Cleaning:
Standards & Certifications
Flammability Standards:
UL 94V-0 rated cover & base
The JS Series slides have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current circuit.
When used as intended in a low-voltage, low-current circuit, the results do not produce hazardous
energy.
H24
www.nkkswitches.com
01/05/18