MODEL: JC-HL
Remote I/O JC Series
HUB MODULE
[4] OPTIONS (multiple selections)
Communication Mode
blank: Full-duplex
/H: Half-duplex
Other Options
53
(2.09)
blank: none
/Q: Option other than the above (specify the specification)
SPECIFICATIONS OF OPTION: Q
EX-FACTORY SETTING
115
(4.52)
/SET: Preset according to the Ordering Information Sheet
(No. ESU-9041)
FUNCTIONS & FEATURES
73
The HUB Module for HLS (model: JC-HL) extends total length
of network cable and branch cable of HLS (Hi-speed Link
System). Total max. length is 2.4 km when transfer rate is 3
Mbps. In order to connect the JC-HL, the master unit
configuring HLS must support HUB module.
(2.87)
mm (inch)
MODEL: JC–HL-[1]-1[2]-[3][4]
HLS is the abbreviation for “Hi-speed Link System” of Step
Technica Co., Ltd.
ORDERING INFORMATION
• Code number: JC-HL-[1]-1[2]-[3][4]
Specify a code from below for each of [1] through [4].
(e.g. JC-HL-7-12-R/H/Q)
RELATED PRODUCTS
• Specify the specification for option code /Q
(e.g. /SET)
• High-speed link system I/O modules (model: R7F4DH,
R7K4DH, R7HL, R7FN etc.)
• MP2200/MP2300 series use HLS master module (model:
MPHLS)
[1] I/O TYPE
3: 3 port (trunk 1 port, feeder 2 port)
7: 7 port (trunk 1 port, feeder 6 port)
GENERAL SPECIFICATIONS
Number of port:
JC-HL-3: Trunk 1 port, feeder 2 port
JC-HL-7: Trunk 1 port, feeder 6 port
Max. number of inserted HUBs: 7
(Depending on specification of master unit)
Connectable devices: The products conforming to HLS
Connection
TERMINAL BLOCK
1: Tension clamp terminal block for power supply
RJ-45 Modular jack for communication
[2] COMMUNICATION CONNECTOR PIN ASSIGNMENT
1: 3, 4 - 5, 6 pair wiring
Network: RJ-45 Modular Jack
(M-System HLS related products standard pin assignment)
2: 4, 5 - 3, 6 pair wiring
Power input: Separable tension clamp terminal
Power on LED: PWR (green) turns on while the power is
supplied.
(Ethernet LAN cable pin assignment)
[3] POWER INPUT
DC Power
HLS COMMUNICATION
Communication mode: Full-duplex or half-duplex
Network cable
R: 24 V DC
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
R5: 16 - 32 V DC
• Shield cable
ZHY262PS (Shinko Seisen Industry Co., Ltd.)
ZHT262PS (Shinko Seisen Industry Co., Ltd.)
• Dual-shield cable
(Operational voltage range 15 - 33 V DC, ripple 10 %p-p max.)
ZHY262PBA (Shinko Seisen Industry Co., Ltd.)
JC-HL SPECIFICATIONS
ES-9041 Rev.3 Page 1/11
https://www.m-system.co.jp/