DATASHEET
ISL95810
FN8090
Rev.3.01
Jun 5, 2020
2
Single Digitally Controlled Potentiometer (XDCP™) Low Noise, Low Power I C
Bus, 256 Taps
The ISL95810 integrates a digitally controlled potentiometer
(XDCP) on a monolithic CMOS integrated circuit.
Features
• 256 resistor taps - 0.4% resolution
The digitally controlled potentiometer is implemented with a
combination of resistor elements and CMOS switches. The
position of the wiper is controlled by you through the I C bus
interface. The potentiometer has an associated volatile
Wiper Register (WR) and a non-volatile Initial Value Register
(IVR) that can be directly written to and read. The content of
the WR controls the position of the wiper. At power-up, the
device recalls the contents of the DCP’s IVR to the WR.
2
• I C serial interface
2
• Wiper resistance: 70Ω typical at 3.3V
• Non-volatile storage of wiper position
• Standby current 5µA max
• Power supply: 2.7V to 5.5V
• 50kΩ, 10kΩ total resistance
The DCP can be used as a 3-terminal potentiometer or as a
2-terminal variable resistor in a wide variety of applications
including control, parameter adjustments, and signal
processing.
• High reliability
- Endurance: 200,000 data changes per bit per register
- Register data retention: 50 years at T +75°C
• 8 Ld MSOP and 8 Ld TDFN packaging
Related Literature
• Pb-free plus anneal available (RoHS compliant)
For a full list of related documents, visit our website:
• ISL95810 device page
VCC
RH
SDA
WIPER
REGISTER
2
I C AND
SCL
WP
RW
CONTROL
NON-VOLATILE
REGISTER
RL
GND
FIGURE 1. BLOCK DIAGRAM
FN8090 Rev.3.01
Jun 5, 2020
Page 1 of 14