DATASHEET
ISL91301A, ISL91301B
Triple/Quad Output Power Management IC
FN8966
Rev.4.01
Feb 20, 2020
The ISL91301A is a 4-phase, three output programmable
Power Management IC (PMIC) and the ISL91301B is a
4-phase, four output programmable PMIC. They are
optimized with highly efficient, synchronous buck
converters capable of multiphase and single-phase
operations. The devices can deliver 4A per phase
continuous output current for 2.8V to 5.5V supply
voltages or 3A per phase current for wider 2.5V to 5.5V
supply voltages. It features four buck controllers and can
reconfigure its power stages to these controllers. This
flexibility allows seamless design-in for a wide range of
applications that require high output power and small
solution size.
Features
• Triple output 2+1+1 phases (ISL91301A) or quad
output single phase (ISL91301B)
• 4A per phase for the 2.8V to 5.5V supply voltage,
VIN_SEL = AVIN
• 3A per phase for the 2.5V to 5.5V supply voltage,
VIN_SEL = GND
• Small solution size
• High efficiency (93% for 3.8V /1.8V
)
IN
OUT
• Low IQ in low power mode
• Proprietary control scheme reduces output capacitor and
supports fast load transient (such as 50A/μs per phase)
• ±0.7% system accuracy, remote voltage sensing
The ISL91301A and ISL91301B integrate low
ON-resistance MOSFETs and programmable PWM
frequency, allowing the use of very small external
inductors and capacitors. They feature automatic Diode
Emulation and Pulse Skipping modes under light-load
conditions to further improve efficiency and maximize
battery life. The ISL91301A and ISL91301B feature a
controller based on the proprietary Renesas R5
technology which provides tight output accuracy and
load regulation, ultra-fast transient response, seamless
DCM/CCM transitions, and requires no external
compensation.
• Programmable PWM frequency from 2MHz to 6MHz
2
• I C programmable output from 0.3V to 2V
• Independent Dynamic Voltage Scaling (DVS) for each
output
• Soft-start and fault detection (UV, OV, OC, OT),
short-circuit protection
• 2.570mmx2.919mm 42 ball WLCSP with 0.4mm
pitch
Applications
• Smartphones, AR/VR glasses, drones
• Optical transceiver modules
In addition to the standard interrupt, chip enable, and
watchdog reset functions, the ISL91301A and ISL91301B
also feature four MPIOs and two GPIOs capable of
supporting SPI, I C communication protocol, and various
other pin mode functions.
• Artificial Intelligence (AI) processors
• Client/enterprise/data center SSD, NAS
2
Related Literature
For a full list of related documents, visit our website
• ISL91301A, ISL91301B device pages
95
90
85
80
95
90
85
80
Vin = 3.0V
Vin = 3.8V
Vin = 5.5V
Vin = 3.0V
Vin = 3.8V
Vin = 5.5V
75
75
70
0.10
70
0.10
1.00
Current (A)
10.00
1.00
Current (A)
Figure 1. Dual Phase Efficiency (VOUT = 1.8V),
Load Sweep (0.1A to 8A)
Figure 2. Single Phase Efficiency (VOUT = 1.8V),
Load Sweep (0.1A to 4A)
FN8966 Rev.4.01
Feb 20, 2020
Page 1 of 59